Dust filter.
There is an AeroCool Aero One case, the question is there is a dust filter on the front panel, you can put either 3 x 120mm or 2 x 140mm fans, but everyone puts the dust mesh in different ways, you can put it inside the case, or you can, outside, t .e. 1) you can put a dust mesh first, then fans, and you can also put fans first, and then a dust mesh and then a cover, everyone puts it differently, but how will it be more efficient?
Yes, something so that that way does not look very good. Vidyaha is something right next to the front wall, there is almost no gap at all. Put your hand under the vidyahu, how best it will be to inflate from the front turntable, and leave it. Ideally, it would be three centimeters from the lower location.
And the top turntables should blow up.
There is a gap, but I also thought that it would be better to blow from the lower location, as you wrote.
It's just that earlier, when the dust filter was up to the fans, there was a lot of dust, but now it gathers less dust, I decided to disassemble everything and clean each fan, and even on the video camera, but now it seems that the dust is being blown out or something.
Horse567
Horse567 wrote:
before, when the dust filter was before the fans, there was a lot of dust, but now it gathers less dust ... it seems that the dust is blown out or something.
So it is - the mesh (like any other obstacle) reduces the air flow, because of this, the airflow decreases, because part of the dust settles on it (it has to be cleaned more often). But, having removed the mesh, it is more likely that something can get into the case that this mesh could delay with the size of its cells.
And on the front panel, which is better to put 3 by 120 mm or two by 140 mm, as I currently have.