GTX 980 TI is overheating
Asus Matrix Platinum gtx 980 ti in games is heated to 73, the entire Internet clambered everywhere up to a maximum of 68 I got married? Who understands please respond should I change the map?[Denis]
.Open the case and next to the card blowing on put the valve 120mm.
A familiar theme! Totally agree. I was a mess, but with only 200mm. Knocked 14C.
[Denis]
[Denis] wrote:
Of course,I understand that you are full of disturbances.But the 7950 when 4000об/min quieter than the 4890 at 3000+.On 570GTX with 3000+ quieter than the 4890 at 3000+
This type of delirium delirium? As the process and the differences in architecture affect the noise? You specifically tell me the model of your video card, or show her a picture. But in any case, 4000 rpm is just a cleaner, not in terms of the ingestion of dust and noise.
Easier to adjust speed in MSI Afterburner so that the speed at the peak was at least 2500, if none is still too hot then reduce the acceleration.
Here's an example of double girder Havana 4
Then I adjusted the fan speed so that at the limit they were around 2000 revs. And it is a test where none is fully loaded in games the loading is usually in the region of 70% -90% and vidyuhi not so is strongly heated.
666Lucifer
Run heaven 4 and look at the temperature with different speed coolers, and then you can either reduce the acceleration or if the noise does not stop to increase the speed of the fans. The main thing here is just to see how it will behave vidyuhi at full load. And Yes if you play games without the rifle and then put it on the air because a stable 60 fps better for example unstable 70-80 fps with a full load the GPU like in terms of image and in terms of temperature because none will be less loaded.
STANDS of Milivoje
The dropsy there is one drawback, it after 2-3 years of operation must be refilled with refrigerant. I have Arctic cooling hybrid for 3 years, after which the liquid was not enough for normal cooling (liquid evaporated through the rubber tube), I finally just removed and put the stock impeller. Madseason is highly dependent on the geometry of the fans. Modern engineering solutions are much quieter than their predecessors.
Ryazancev
I'm two years are going to change some. Usually do one every two years. So there's still time.
I also heard somewhere this topic in terms of refueling.
MagicHero
drove in haven 4 maximum results which recorded is 72C 99% 58% 1689RMP it at stock settings without overclocking, etc This is a normal result should cast spells or not? Thanks in advance for the answer
666Lucifer
normal, even have stock fan speed, I can still increase them, then there will be less noise and not much will grow. I say again, you can game without a rifle and play and you have none hammer for all 99% empty and therefore overheats.
666Lucifer
666Lucifer wrote:
With the plane more than 60 fps does not issue
And what is the point of having more than 60 fps? put the plane and the problems with the overheating will go away. 120 fps only need dynamic shooters and other games 60 for eye.
666Lucifer
There are under 100 and card the rules of breathing and depending on how demanding the game to the graphics
STANDS of Milivoje
+1
MagicHero
This type of delirium delirium? As the process and the differences in architecture affect the noise?
The fabrication process affects the temperature.The smaller the cooler needs to be the map.Hence the speed is less,cooler quieter.But this theory is not true everywhere.Here,rather, the cooler it is better to do steel.
СпойлерXFX 4890:
Palit 570GTX:
HIS 7950:
So on my 7950:
666Lucifer
The tachometer shows 1850 - 1900
You can safely raise the rpm to 3000 and trying to drive the card.73 degrees is nonsense.
[Denis]
[Denis] wrote:
So on my 7950:
Horror on the turnover, such a valve on 4000 needs to roar strongly. About 4890 I have just XFX 5850 with the same fan and at full speed roars like a vacuum cleaner, there and the air flow back vidyuhi blows hard.
666Lucifer
http://www.e-katalog.ru/k157.htm
gmaci the right options, and choose. Only read first about monitors, see the video on YouTube. Many different technologies affect the price.
Ryazancev<Ryazancev
Thanks for the response) games no matter what matrix to take?
666Lucifer
If the richness of images, the response time and the review at large angles is not critical, then any matrix. To better understand the matrix it will take 2-5 minutes, then elbows not to bite. And choose the resolution and diagonal size wisely, also I advise you to read the optimal values.