Regarding extra Coolers
Is there such a stray, which connects all third-party body cooler, because the motherboard have nowhere to connect. To stray ate from the PSU or from the wall outlet. And if so, post a link of the FPGA, and then it becomes hot we must prepare for the comp to flyIs splitter https://www.citilink.ru/catalog/computers_and_notebooks/parts/coolers_aks/869508/
If you want something more complicated, that is, the fan control: they can control the speed of each of the connected coolers.
Sanchez Ramirez
Well he eats from one of the fan connections? The load is not large it will be?
I don't know what maximum current gives plug of the cooler. USB 2.0, for example, is 500 mA, but however USB hubs are used quite often.
The fan controller should be the controller of power, so it should be safe to use. I never had to use it so rather not. Shake people to overclockers - there is, most likely, you will answer all the questions on the topic.
Ripper Man
There, I even in the oldest building (now 14) has a piece inserted into the slot of the drive. And you can connect at least 12 fans. There are 4 whirlings which can change the speed of the fans to make loud or Vice versa to better cooled + display with temperature in the housing. These pieces are also sold separately.
Ripper Man
And how many do You have coolers in the case? 1 is usually enough for blowing (usually from the bottom) and 1 on blowing (usually at the top, because hot air always rises). Because the fans are at CPU, graphics card and power supply. If the 2 coolers in the case are not enough, replace the thermal paste on the CPU and the transfers on the graphics card. Either the body itself (the boxes) may in case there is no room for normal air circulation. Note that if coolers a lot, they can weaken each other!!! Selection of your desired gadgets then https://www.regard.ru/catalog/filter/?id=MjA0MDsyLDE1OTktNDExMSw7NTU5LDAtMCw= I like this https://www.regard.ru/catalog/tovar225658.htm (I have a large case, which will fit a lot of coolers).
Alexey_Gamer
I have 2 on top and 1 on the back blowing, one in front on blowing. this is a standard and was in the corps. but something they have little spinning, the rear is generally sluggish to some. on the body there is a button to increase the speed of the top two(probably) but it's not working.(maybe because I worked two Vertica and connected to one input)
Perhaps this is why. Try more coolers to be cleaned and lubricated on dry they are even with a good washing may not spin. Don't forget the blades to remove dust, it 1) increases their mass, decreasing speed, and 2) accumulate unevenly, it may be faster to wear out the cooler. And in addition, You have an imbalance, just blowing on 1 and 3 whole demand. They state vacuum will do)) because the rear still blows out cooler power supply. Sluggish coolers try to remove and rotate laposte fingers held to his ear. If there is audible friction, then disassemble and look for the cause.