Temperature after driver update
Hello, I have such a problem, I had to update the videodrive because the old ones were not supported in the premier pro. I updated, installed the latest version, before that the temperature was in the usual state was 32 degrees, now 42. Video card geforce gtx 1650 4 gb. Please help.Avdyslav
That's not a cause for concern. Most likely, the ratio of minimum frequencies and voltages has shifted slightly in the new drivers (CURVE).
You can poke "adaptive" mode in drapes (PANEL INVIDIA). Allows you to throw off voltage and frequency as much as possible when there is no load on the GPU.
If at full load with the old value of turntables the temperature is the same. You can close your eyes to the situation.
Ryazancev
Thank you for your help. By the way, I've seen you somewhere, it seems you're the same as I helped 3 years ago.
Ryazancev
It didn't help. Maybe the cooler got quieter, I'm not sure, but that's the way it was. Went to the 9th to give 2 with unlimited phps, the temperature was 52 and worked venters on the video card
Avdyslav
too many factors can influence the temperature. for example, heating, a hole in the radiator, dust-covered holes in the body of the fart.
Are you sure it was the firewood that caused the temperature to jump? comparative tests did?
yes and 40s in the downtime isn't that much to make panic because of it
Pekabir
yes, I'm sure I have a 0 percent load on my graphics card and a temperature of 42 or more. Before the update, everything was in a good place
Avdyslav
In the furmark sweating at load. If something goes wrong, you'll be able to figure it out.
Pekabir
And how to check, let's turn on and what? What is the value of normal and what is bad?
Avdyslav wrote:
yes, I'm sure I have a 0 percent load on my graphics card and a temperature of 42 or more. Before the update, everything was in a good place
You sure? I'm not sure it's okay.
As you have already written Most likely the ratio of minimum frequencies and voltages slightly shifted in new drivers again the heating could also raise the temperature, if under load the temperature has not changed there is no sense on this to bother, if you are so worried can blow a com from the dust.
saa0891
Well I have a comment on the top where I tested in furmark. Is that the norm? And yet, how to change the ratio?
Avdyslav wrote:
Well I have a comment on the top where I tested in furmark.
So you compare with what you had before with what you have now, for example in some game.
Avdyslav wrote:
And yet, how to change the ratio?
If you don't know about it, you don't have to go in there, as you've already been written, there's no reason to be concerned.
If you still want to twist the MSI Afterburner there can be twisted anything, but I would not advise you.
Pekabir
I've got it back on, but it's normal. Karoche, included resolution 1920 1080, smoothing 2x waited half an hour, min temperature 41 max 65, phps min 36 max 39