searched and cannot be found - Toyota Mark II, 2.5 liter, 1991
I’m looking for everywhere to go up and
I can’t find it anywhere, I decided to look here, maybe someone can tell me something and
the essence is as follows, the stand was partially dismantled
and an attempt to polish the stem was unsuccessful, because it is really dead
at first I couldn’t immediately move the stem, but that’s why it flooded ... and the oil kicks out
and here you can see how dead it is, it just falls by itself
now the bottom line — looking for a pair of rear coilovers in good and close to perfect condition from 81/90/100 marcobraza or nissan silvia. if someone somewhere on the forums meets or may be available, please get in touch
Well, I told you right away when you first posted the photo, that there was on the sink counter.
vitekV
in our deryabino all the factories were destroyed. there is absolutely no bullshit here. there is nowhere to even balance the cardan. without saying just do it already about the many opportunities that, for example, Novosibirsk and many throughout the country have.
that's for sure ... moreover, of those services that still have everything at cosmic price tags
It's not even that you don't know. no one will mess with you, run because of your spare parts. and who will control this process after all. I also wanted to send the block to Khabarovsk. yes, cheaper. but here at least I will keep these boobies under control. and they mess up there, and why am I going to show them there?
Padre
Is it possible to send the part somewhere, to the same Nsk?
well, sending back and forth will cost 4 thousand at best 3 ... plus work ... what will happen in the end ... seriously, we are in such a backwater that it’s already sickening ... and again, to whom to send it, I don’t know a single office
yes, it's all expensive. only shipping how much money will gobble up, sometimes it’s not worth that money
Padre
And how about grinding off everything that is eaten and restoring it to normal by tape welding or spraying? We have an office in Moscow time - mechanics, they restore printing presses, for example. I think you should have one too.
in our deryabino all the factories were destroyed. there is absolutely no bullshit here. there is nowhere to even balance the cardan. without saying just do it already about the many opportunities that, for example, Novosibirsk and many throughout the country have.
And how about grinding off everything that is eaten and restoring it to normal by tape welding or spraying? We have an office in Moscow time - mechanics, they restore printing presses, for example. I think you should have one too.
no alterations, either digest the cups on the body, or the cups on the rack, or change the top cup of the rack