Car diagnostics - Toyota Sprinter Trueno, 1.6 L, 1999
I bought a USB-COM wire for diagnosing my car (25-pin))
here is the actual cord:
Although it was necessary to buy a 9 pin, like this:
You need to make the following scheme:
So let's see the pinouts:
and for what I bought:
we get that instead of pins 5 and 6, 6 and 7 will be used!
The program for which the diagnostics are carried out is called CarTester8000StableEdition. She is discussed on the forum of the Karina-Karona club. As I do, I will post the results of pampering.
if I'm not mistaken, the program is cool. current it seems on the laptop for some reason it does not show more than 6250 rpm :) but yes, you can see a lot of things.
25 ob.sec * 255 = 6375, one of the OBDII protocol "pickers" wrote on gtextreme.ru, GA-shnye high-torque motors cannot be checked. in general, the program has a very wide functionality, plus it's free =)
For the diagnostic port, of course, it would be good to find a chip, there must be a mother (by car). I just wanted to plug in wiring with contacts. the size of the port is small, it is located near the fuse box. The most expensive in all this is only a laptop =) the cost of usb-> com (50 rubles), the cost of a 25pin mother chip (8 rubles), the MGTF wire and the capacitor are inexpensive, the program is free =)