If your race is dismantled and you have a lot of time :) - Toyota Celica, 2.0L, 1991
So, now, as the fifth month ya pisikhod :)
from not doing anything, I was confused by wiping the dirty details of my race :) here it all goes to chim) the formula is simple a
lot of free time + disassembled race = head off :)
the first photo, we have a cylinder head cover. at first I just wanted to wipe it, then I decided to rub it with a hairbrush and finally covered it with powder paint :)
photo number two, at our intake manifold, the same story as with the cylinder head cover :)
photo number three, we have a little thing (I don’t know what it’s called correctly), in general, there are a lot of temperature sensors in it, it’s under a cool :)
the photo number is black, we have a cover of the exhaust manifold :)
photo number five, we have a generator. since there was not enough strength to disassemble and paint, too, he just remained shining :)
photo number six, at the fart, came rusty and ugly, otpidoril and painted with super paint) while resting in the garage :)
photo number seven, at we have buttons, just covered with a film :)
photo number eight, at us potdon :) the photo turned out to be shitty because of the lighting and shit photo :)
photo number nine, we have a side timing cover, photo-shit :) but it is matte black :)
Mileage: 225,000 km
Well done, nice to watch. The pipes, as I understand it, you bought new ones, and not the old ones "repainted"?
conducted the experiment unsuccessfully :) the button was erased) but nothing, the second control unit was somewhere :)
yes well you chigo :) what plagiarism? I don’t believe in these words :) you need to do whatever you want :))))
and you don’t need to deny yourself with flowers :)
I painted all the pieces of iron except the release and potdon with powder paint :) metal and degrease :) powder paint does not keep the temperature more than 250 degrees like: (
for powder painting they took only a thousand rubles, painted: valve cover, intake manifold, exhaust manifold cover and garbage for sensors :)
The whole issue had to be painted, as it turned out to be painted with powder, it makes no sense because the paint will crack and fall off from the temperature, but I cleaned the pipes before I found out :) I found it like a good paint "tikurila" for her boilers paint, keeps the temperature more than 400 degrees :) it cost a little a jar of 600 rubles :) here's the principle and that's all) the
most important thing is to clean and degrease well before painting :)
cleaned with trowels, in any construction department where all sorts of drills and so on are sold, a metal brush, in general, the current is round and fits on a drill) cleans very well) for three evenings I stuck to clean everything because I liked it) until they stopped me I was ready to clean the whole car with them :)))
Of course plagiarism is bad, but I can’t help myself! I will paint everything the same, but I promise, the colors will be different! Can you tell me about the painting technology? Are there any differences in powder painting?
In general, well done, the engine compartment will be at its best!
lubaya
just like that =))))) class!
I wonder why you were so wonderfully surprised on Ave =)
Climate control unit? he goes like that for all 18 :) in the 20 salon everything is a little different :)