There is an idea of ​​tuning type, advice is needed! - Toyota Camry, 2.2L, 1992
I've been skating without moldings for a couple of years now: (
Buying new ones is absolutely not budgetary!
Used moldings for disassembly are sold only complete with a door :))
The doors on the left side were somewhat damaged when communicating with a dog (like a Caucasian), so it will need to be repaired and painted.
On this basis, I had an idea, but what if the grooves for the moldings are putty, or welded flush?
Shpaklo, as I understand it, will not last long, once I will slam the door and the PPTs.
What about welding?
The situation is the same for the lower moldings. Under these thresholds it will be necessary to undermine the doors a little.
There is an option, of course, to buy self-adhesive moldings, I have already even found which ones, but:
1 - they need to be adjusted in width, and this is hemorrhagic;
2 - they are black, and the black stripes along the board look calico.
And there is also the most budgetary option - to stick strips of white film instead of moldings :)
What do you advise?
If it is possible to brew it, you can still seal it up and putty from the inside with fiberglass.
save money for native moldings or attend, like Muslims, Friday prayers for Toyota showdowns. No tapes, putties or welding! =
take plastic such as PVC, and remove them yourself by hand. You can also go to cartoons with the same plastic, there you only limit the length to size, the profile itself goes alone along the entire length.
Good afternoon, COLLEAGUE :))) And a neighbor. I have a second Camry 2.2 car (by the way, Sevastopol registration) and recently these niches for moldings as well as lower rubber pads were canceled. the doors immediately become visually higher and more :))) so that everything is buzzing but it's up to you