Start-M preheater installation — logbook Toyota Corolla 1991
I installed an engine heater on my car, since we have harsh winters and the car is always needed at hand. The choice of heater was obvious, Start-M, it is produced in our city and for a specific engine.
Having unscrewed the two bolts of the starter, pushed it to the side and opened a view to the plug in the block. It then had to be knocked out and replaced with the one supplied with the heater.
Using a crowbar and a hammer, knock out the plug.
With a screwdriver, turn the cap with an edge.
We apply sealant to the plug and gently
press it in.
Screw into the plug of the fitting.
Remove the stove return pipe.
Installing a tee.
We put the heater and install the starter in place.
We fill in antifreeze, remove air plugs, warm up the engine.
Issue price: 1,600 ₽ Mileage: 208,000 km Company: TyumenAvtoDetal 
well, how is he?
I also want to put it in, but where can I get the socket ... and the autonomy with the installation of 26000 ...
it works fine, half an hour and the engine starts in any frost)) the problem disappears immediately, about the socket, I live in a private house and there are no problems with these)))
awesome topic! especially in the north! 11
and we used to have TENA in Muscovite, such crap warmed up the oil in 2 minutes ... and voila la))))) backwater in any weather)))))
having gasped, only so that there is a neck in the radiator, and the expander is full)))
Greetings! Well done!
Can you tell me if the plug is included? what size is she?
There is a desire to put the same on the Prius.
Why is there no drain in the block or what? or not get close. In extreme cases, take it from the return of the stove and feed it into the upper radiator pipe, all through 2 tees, rather than plug it in with a plug. Yes, and the bowler hat sucks.
Only the okhzh fence was taken from you not from the return of the stove, but from the supply.
like so, I have a 1C motor-analogue of yours, and if you feel the pipes of the stove on an unheated engine, then the one on which you have a tee heats up earlier, which means it has a stove supply. And you have a tap on the same pipe, and the taps usually go to submission!
I have a fence from the block made, from the lowest point, so to speak, and the exit to the top.
You are right, but what does the radiator stove have to do with it? I'm going to heat the engine with a heater, not the stove radiator.
and a fence from the block (lower point), and in the section of the supply pipe to the stove, the supply (upper point), since it coincided with the supply to the stove radiator, a tee was placed there. but warm antifreeze circulates through it to the head through a large pipe from which a pipe exits to the stove.
Greetings! I want to put my father on Shniva, because in the village in the forest there are frosts. There are many different choices: Start, North, Icarus, Longfei, etc. I want 1.5 kw. What is the best place to stay? it seems like good reviews on the Start, but they are also different: (with and without pomp). I will be grateful for the answer.