Replacing the oxygen sensor and rear pads. — Toyota Celica, 2.0 liter, 1995
Serious parts have arrived! ! ! YAHOOuuuu!
Today we will change the most necessary.
It's a lambda probe.
and rear brake pads
Because of the lambda, the car was driving very badly and was dumb on a cold one like ... in general, this push-pull has already hesitated!
Naturally, it wasn’t without an ass-handed hello again ...
Nuts have not changed for 200 years.
But they were ripped off well, there were no faces left.
They didn't look like nuts at all.
I had to chop them with a chisel and unscrew them with
pliers.
dead sensor)
Now we are doing a transplant - we splice the old plug with a new sensor.
Change Denso to Denso
All in heat shrink.
And heat shrink on top).
Govnogatki change to new, bronze!
And prem from the result) Beauty)
It was also necessary to change the rear pads, the same ones that had recently been worn obliquely due to the guides.
I admired the TRW inscription for another ten minutes.
Then I put on the wheels)
Well, everything, the work is over, we close the shop and go home to celebrate!
Happy New Year everyone!
I also set TRW back to myself, beauty. It's nice to hold in your hands :)
Well, how about lambda? Vomit? consumption dropped?
Works exactly, smoothly, quieter, consumption fell by 3 liters! How smoothly does it ride?