How I polymerised wheels - Toyota Carina ED, 2.0L, 1996
Well, I painted the wheels white))))
Polymer coating, if anyone knows, is a powder paint that is applied from a special gun. paint gets + charge and product -. the paint adheres to the product and is then baked in the oven.
after it cools down and the paint becomes stable (this is about 2 days) the product is ready ... the coating is more durable than from a simple paint.
so)))
take disks
... wash and clean with sandpaper and acetone ... the middle
we clean from the boiled rubber. inside part of the disk from the weights of the adhesive film from them and bitumen, I had it, well, a lot ... I was still wondering why recently I have a vibration))) remove the gloss of the old paint from the front side. where chips, etc., are cleaned. I didn't have them)
after we cleaned the discs we washed them ... we put them in a bath with a chemical solution
where the discs are deeply cleaned ... can not be kept for a long time. otherwise it can be very bad)) further we wash in 2 more baths ...the disk becomes like this
then we hang it on the traverse
and the discs went again through 3 degrees of washing-cleaning. dalie in drying after drying go to painting ... where paint crumbles
then they go to the oven where they are baked for 20 minutes.
...
after leaving the oven
cool down
well and packaged
well, everything is on SHINOMANTAGE))))pictures of how they are on the car a little later. but oche bite))))
in general, we will test the polymer coating how strong it is)))))
Well, here are the pictures of how it looks on the car))
available on Sako and Vanceti. there is a screen at the factory, in Tyumen.
well, our biggest at CHP 5))
mmmm. why should you heat them with a lamp? ))
after washing with chemistry, they go into the dryer where the temperature is 100 degrees. after drying they go to paint
Max sandblasting is not present ... because we are not engaged in this ... but we had no time to take it somewhere. And there is no time. so I prepared it myself)
Yes. if someone will paint. then prepare the discs well. it's better to just rip off the old paint ...
otherwise I was on a wild one ... I missed the kid, the paint swelled a little))
Seryoga, Max photo will be required ... they are just dirty now. there is no time to wash ... and the toad presses the loot for the sink)))) when there is a Karcher at work)))))
Buddy, sorry for the offtopic.
Tell me about the body kit, this is Varis as far as I can see. How much does this pleasure cost and where can you buy / order it?