backlash steering 2107

Better:-) but weed remained:-(

At the beginning should be good, and then the lubricant will disperse and will again beat )

Now I put on the car another look

Backlash is the trouble with 07's steering shafts. Me new bearings didn't help

and what about axis I think)

Here about the axial play it in gear Yes must be backlash

I may be wrong, but the backlash should be not scattered reducer, and then after a few years of operation jugula, is it obvious?) I have 10mm backlash I don't see it, on the contrary, to anything such a sharp turn I think

That's the head, I was reading that ))) really long time

here is a little www.drive2.ru/l/288230376151972026/
that's epic, like more was www.drive2.ru/l/4097084/?page=0

monster62

after everything you've done, a lot hemorrhoids for shaft replacement? don't be ridiculous

there is a description ?

then half is not visible ))))

after everything you've done, a lot hemorrhoids for shaft replacement? don't be ridiculous

something hemorrhoids to fuck the shaft to change

sad... need to put 08 shaft... at least without Eura

alexokta

interestingly, the AVTOVAZ engineers know about it?

Why should they?)a lot of what they know, but will not do.

since the whole steering column factory so you know) they made it up. The difference in the gearbox and that 01й steering shaft direct view of the pin, and the 05 is made through cardanic those for Dumka AVTOVAZ steering needs to be more safety during an accident. So using factory parts not violate the design of the car

Gimp54

order Turner PTFE sleeve to make will be "eternal"

interestingly, the AVTOVAZ engineers know about it?

the backlash is in the binoculars in the fastening Assembly steering shaft, there are needle bearings in the rubber holder as the author of the picture. Well, to be a caveat that cardanic steering you hit the brake pedal, it will have to remove and bend from another angle www.drive2.ru/l/6535562/

I also want 05 gear and the shaft to deliver. There difficulty there are some? The backlash will be terrible you say? I have a simple reducer dead still will be changed

when I altered to 3ке steering with a 01 on 05ю, the binoculars didn't like this node is the steering wheel does not lock and pulls with these rubber bushings. In the end, the father of the PCB machined two bushings, instead of the regular ones in the end at the helm of a small current (relative to the steering shaft) the top-down and left-right play is almost there

That's the idea! But that's not hunting again to disassemble all the wheel will be tighter. Just here you can customize the sleeve size so the backlash was minimal.

order Turner PTFE sleeve to make will be "eternal"

Two sets were taken in one new the grease washed out and the needles fell out, here are the details, there is the very iron moving if no backlash:-)

Changed the bearings 3 times, 3 times, only got lucky and the backlash is gone. It all depends on their quality. They even one party come in the store, all different.

To measure? 20mm approx

The inner diameter of the bearing is what?

Then they nafig not needed, the wheel on the classics are not so easy

Long ago it was but remember.
Sharpened me from kaprolon such sleeve.
Grooved inside(during heating is very tight to twist it)