Replacement of bearings transfer case front drive shaft.
Full sizeA few days ago, dismantled razdatki, in the General sadness in the fact that due to neglect in taking care of slotted and a crosshead smashes the front shaft of the transfer case.
At the opening, and replacing it turned out that the landing backlash, not much, but enough, and future problems may be...
The video shows that transfer case very clean oil changed 15t km ago and not had time even to change the color of your.
And that's what the RAID was inside. The remains of the clutch is possible but I'm not sure shavings from the chain. The chain was suspiciously loose.
Transfer case drove this oil for about 85t km, the color was black, the smell of burning
It is not necessary to get to this point. Maybe it finished off the shaft bearings, the fact that the presence of radial runout from a vibrating gimbal + bad oil, not changing regularly but still very liquid leads to such a sad result.
Set the "right" bearings have characteristics much better than the original bearings.
Full size 
Full size
Full size
Full size
Full size
Full size
xbard
I understand that boarding is not restored? put the bearing of the same size, with smaller gaps?
* that by the way went perfectly
matatari
The seat is not restored. It is almost impossible to restore correctly. Recovery options, but they are already as repair. Open bearing that I was shaking in the video is a new original bearing. And there was the other bearing is not original to withstand the stresses several times more.
There is a variant of Loctite to restore the gap to 0.3 on the side there are compositions. But they also need to be able to use+measuring tool needed.
matatari
The seat is not restored. It is almost impossible to restore correctly. Recovery options, but they are already as repair. Open bearing that I was shaking in the video is a new original bearing. And there was the other bearing is not original to withstand the stresses several times more.
a number of other bearing prompt?
I was restored. Navarro wasted on coordinate machine
the number of the "other" does not say? or a secret?
The seat is not restored. It is almost impossible to restore correctly. Recovery options, but they are already as repair. Open bearing that I was shaking in the video is a new original bearing. And there was the other bearing is not original to withstand the stresses several times more.
I understand that boarding is not restored? put the bearing of the same size, with smaller gaps?
Also stalknulsya such trouble. There's a Seating design kind of sucks. And the new "enhanced" open or closed?
The shafts are loose and are not parallel, because the transfer case as can be seen opened.
breaks seem to fit under the bearing and not the bearing from the fact that it is too narrow in comparison with the old bodies, where the position of the eternal