Rear door noise - Toyota Camry, 3.0L, 2004

Everything you have is great, but only for the photos you need comments to make everything clear.
Wheelbarrow class. I do the same. I also want to glue it so as not to hear the spikes in winter.
We wait!

aaa))) Well, thanks)))
I also want to make the backlight of the legs, but I can’t think of what is easier to connect to ... I want the light to come on when the door is opened!

I mean, I found something to do with the right hands 8-)

what do you mean "confused"? :)

Greatly confused!

1. We buy 2 diode strips.
2. We fix it under the torpedo under the feet using plastic clamps.
3. Remove the trim from the front left pillar.
4. Under the casing you can see the wiring harness with the plug.
5. I do not remember exactly which wires to connect "+" and "-", but empirically and with a diode tape, you can pick up the "+" which controls the interior lighting. A little later I'll see how mine is.
6. Connect 2 wires "+" and "-" to this harness and lower them under the torpedo.
7. Through the entire torpedo you pull the wires to the passenger side.
8. Connect "+" and "-" on diode strips to these wires.
9. Enjoy 8-)

Please tell me if it's not difficult)))

If interested, I can tell you.

Thank you for your help!)))) I'll do everything - I'll show the report)

Do not be afraid, there is nothing to burn there. Find a minus (usually black), and you can find a plus!

Thanks for the detailed report! I have the most important question ... The tapes were bought in the summer, installed, but to which wires to connect "+" and "-" I did not figure out. I will try by poking ... Eyes are afraid - hands do!

------------

30 is not very noisy anyway, but it became more pleasant to ride after gluing :)

Ok, thank
you very much ) The difference is very felt before and after the whole noise?)

This is stuff from STP. Bitoplast-5L is called

And what did you cover the door trim from the inside? What is black velvet material?)

Well, after Shumkov, what's the difference? is the door heavy?

it turns out there are 3 layers right?
1 layer aluminum material
2 layer something like rubber
3 layer some kind of velvet