Sub and wheels - Toyota Corolla, 1.6 L, 2006
The subwoofer appeared unexpectedly ... my brother came to visit and asked if a sub was needed - I did not refuse. I disassembled the console myself, I gave it to the output of the rulers. I pulled the wires myself. Sealed and soundproofed too))))
Forging disks VSMPO 16 for standard rubber. The choice was not great - I wanted forging right away, I liked these. As it becomes unusable, I will buy 17, and these for the winter)) and calipers are bright red, pictures of incomprehensible, all because of the lighting.
Quality is the phone.
1 Remove the silver panels. Starting with those that are near the handle. You need to pull them up.
Which you need to pull higher from the panel.
2 Unscrew the bolts that secure the gear shift knob frame.
Freeing modules that go above
3 we take out Security and heating
4 then we take out the control of the kondeem - it frees the head
At first I managed to disconnect the head only with the blower module and emergency gang, disconnect the wires from the emergency gang - pull it out, and only then you can disconnect the head panel
5 Unscrew 4 bolts and pull out the head.
Then you give it to the radio repair so that you get the line outputs. Just explain better that you need low frequencies for the sub.
The head must be pulled out if only you connect through the lines. And when connecting at a high level, it is not necessary)
The sub is stuck to the seats at close range) perfectly entered the body frame, and thereby secured))
I had a Magnate Charger 130 in the design of a band pass, but single. It plays well on the salon and mediocre on the street (that is, it is not enough to pump the area). From time to time you need to twist the glass, the atoms appear extraneous sounds)))
I don’t like it when the diffuser in the trunk starts working in the opposite direction because of a neighboring car, I have to turn up the volume))))) A friend says that he is practically dirty from the bass ... =) I'm used to = //
They brought me a sub Mac Audi, what is the sequence of disassembling the panel, tell me!
as far as I understand, you are referring to the high level connection method ... the sound quality with this method is lower.