I'm all glowing))))) - Toyota Corolla, 1.8 liter, 2001
Perhaps I'll start describing the finishing touches!
Everything that is done is done by hand!
First, I made a polite highlight in the mirrors! When the car is disarmed, this backlight is on for 20 seconds. Well, for one thing I decided to highlight the mirrors around the perimeter! Photos below.
We finished with the mirrors, it's time for tumanki! Of course, it was possible to put xenon, but since the Toyota Corolla is finally not an exclusive car, it was decided to somehow isolate my korolla from the multimillion-dollar Corolla mountain! As a result, we got pretty nice LED tumanki!
We crawl into the salon! Thanks to the Japs for rewarding my car with an optitron scoreboard! But the rest of the cabin was glowing with a dull green light, but this is not order! Everything was redone under the optitron: white and red colors!
All lamps in the interior shades have been replaced with LEDs.
There was no light in the glove compartment at all (here is my budget car), they did it!)
Number lights and parking lights are of course!)
Look at the pics!
Price tag: 3 000 ₽
Tell me how did you change the backlight in the automatic transmission and heating?) I also took up the backlight, only I change everything to white light. Everywhere I replaced, except for automatic transmission and heating, because there are stencils, green letters, I tried to scrape off, the whole image is crooked ...
2 predator-775, with automatic transmission there are two options: 1If the pattern is double-sided on the stencil, then everything is OK. Gently erase the green dusting with alcohol (it is on the inside), and the main pattern remains on the outside! 2 If both sprays are on the inside, then at first, carefully with the same alcohol, you try to erase only the green spraying, if you zakosyachil and the main drawing, then all that remains is to completely erase everything, draw the desired location of the selector positions in the core and cut the film on the plotter! on the outside, and on the inside you glue the scattering film! That's all!
ZY Everything was elementary for me - there was just a light bulb with a green cap!
Senk) Well, yes, it turned out easier for you) I have a stencil, yes. I'll try the method with alcohol, if I don't drink it earlier)))
And another question) Was the diode tape soldered in the backlight of the clock and climate screen, or did you leave single diodes as well? And then I notice that there are not enough family diodes for a uniform glow ...
In hours and in the climate, smd diodes were soldered into regular places! SMD has a very wide glow angle!
there it is cho)) smd I soldered into the steering wheel and windows ... Well done, cho))
Good article. It turned out beautifully, I also think to change the lights in the tidy. I changed it to white in tarped, conder, buy-in and box, but I haven't gotten to the tidy yet. I have a blue tidy itself, not the same as yours, I think with what to highlight ?!