Connected stopsignal in the tailgate.

Good afternoon.
Sometimes very surprised by the fact that manufacturers save, or simply do not think through to the end all aspects in the Assembly of various sets and allow such obvious blunders. Dvuhruchevaja lamp is already there, add the 4 wiring terminals and the meter wires and the brake lights will be more noticeable and more beautiful and safer, but no, thank goodness for small mercies...
Decided to fix this annoying misunderstanding:
1. Remove the trunk lining (lower part) 4 screw and clips.
2. We find in the common Shoe gray wire — plus from the stop signal, and we select to it corresponding pin in the second part, I picked them up from fear of the connectors to the headlights or the wires from the xenon.

here it is

3. Swap the two green wires in the white block ( where we reversed the polarity) and add the missing Klem in the cartridge (I made itself of similar pins) and pad (came with a few changes from the Klem connector KET or AMP — Chinese xenon)

Klem is inserted into the empty socket. If Clem no you and all other to do having a bypass connector or directly to the positive side of stops.

4. And the last step connect the wires gray wire to the second paragraph and the new wires of the two pads on both sides.
5. Check the operation and assemble the door.

To the left is the finished result — right drain

And here is the result, much nicer and stops much zametnee!

Pushed to the work report Cosmonaut-herder

PS: Incidentally, did the same operation for IX35
And there even easier, plus the stops pulled up to the lights already from the factory, it is necessary to add 4 Clem m 10 cm wire with the two sides) ...