Comfortable turn signals. Comfort Turn Reley (v2 lite)
This record is a continuation of the theme: Smart relay turns from Mail1977. Part 2. With the support of speed sensor. Hack Mail1977.
Unlike the full version:
1) the division into right and left sides of the dimensions in the "Parking lights" no. Combined dimensions
2) separation of each individual indicator no. There is only the division into left and right sides.
So thank you to not only flash the rear turn signals, and hazard lights all the. Makes it kind of easier connection.
3) Board size decreased in two times
diagram of the device
compare full version and Lite
printed circuit Board device
ready motherboard, the only thing left to clean in the shrink
shrink 20mm perfect fit
Information for self-Assembly:
— printed circuit Board
— the fuses when programming is not necessary to install.
Should work with the factory. (High: DF ; Low: 62; Ext: FF).
I тини2313 was from the factory are exhibited: DF; 64; FF — works.
PS: Eugene Ingener73 in MK was from the factory fuses are exhibited CD FF FF, and therefore the device does not want to work.
— programmed the MK from the Board, was podpisala transactions. Once the firmware has dissolved, once the led starts to blink often.
A good DIY )
you have soldered off ?
well done.
what else can you do with turn signals ?
may cause them to say "left" or "right" in Morse ?
not ... !
... — — — ...
this "I'm broke" ))))
A turn later I make a joke what was not ))) the Secret will not reveal )
you have soldered off ?
well done.
what else can you do with turn signals ?
may cause them to say "left" or "right" in Morse ?
not ... !
... — — — ...
this "I'm broke" ))))
I have long been gathered, probably a month ago
I can not do solder
And who said that Carlson was a good man?Pants in a cage on the back of the motor on the Sahara sits -horror.
himiks
Andrew, well, I know the joke)
well you know
We're a little Basil in the blog fun -so a little bit.
on your recommendation and watched "the whistleblower" .
would recommend to repeat .
something new . so interesting !
I'm on break, depart, refreshed, and you are already all reviews bungle
Yes, everything is fine)
thank you .
sorry, if that .
but I latest time something can't articulate it clearly .
all that subtext goes .
Yes, I know that it can blink .
just wonder what else you can come up with a light bulb to do .
for me, the blinking indicator is a miracle, and it is only the beginning .
and I hurt a good man is not wanted and not even thought of .
for his work have been watching for a couple years .
Andrew, well, I know the joke)
well you know
My thoughts are my horses that they are not then they are not visible
and jumped into the distance towards the sunset.
That's good I didn't want and then as a joke:
There were spoons but the precipitate unpleasant remained.
Yes, I know that it can blink .
just wonder what else you can come up with a light bulb to do .
for me, the blinking indicator is a miracle, and it is only the beginning .
and I hurt a good man is not wanted and not even thought of .
for his work have been watching for a couple years .
you have soldered off ?
well done.
what else can you do with turn signals ?
may cause them to say "left" or "right" in Morse ?
not ... !
... — — — ...
this "I'm broke" ))))
The artist can offend everyone.But himiks not necessary-will flash by turns to hiccups and will suffer.
it's not CARDBOARD !
it's PLYWOOD !
you're not here, here everything is serious, not jokes !
I'm kidding of course optimism. If any war is not all die, then perhaps our descendants (or mine) and make such peremeshennoi cardboard...
you have soldered off ?
well done.
what else can you do with turn signals ?
may cause them to say "left" or "right" in Morse ?
not ... !
... — — — ...
this "I'm broke" ))))
You can even trace the laser beams to adjust, showing the trajectory of your hypothetical movement))) (well, you never know where the driver intends lomanut in the next moment), and you can install little screens and they are friendly wink at the girls, and you can finally invent a teleporter and generally away from the topic, turn signals...)))
himiks
all kidding )
everything is possible, the main thing that is more important
PS: tired of the walls and ceiling to paint...
the ceiling is particularly
Yes, hobby is such a thing, which sometimes is not clear to all .
like pay .
certainly better than chips, there are toys under the Sosa-Sola play .
well, here is another approach.
we must also at the same time to throw out the junk, leaving the desired
hire a drunk .
me in the sun drunk over a couple of hawthorn painted the whole ceiling in a steel garage, but first abundantly washed with water .
all kidding )
everything is possible, the main thing that is more important
PS: tired of the walls and ceiling to paint...
the ceiling is particularly
you have soldered off ?
well done.
what else can you do with turn signals ?
may cause them to say "left" or "right" in Morse ?
not ... !
... — — — ...
this "I'm broke" ))))
Mail1977
I honestly got a little PM asking them to thank you and the hazard lights with one button)))
If the Tignes 2313 to replace 4313 sort of memory twice and can be done...But in the button of the alarm system to make a separate device"one button two devices even easier...
Yet such a proposal was received that the emergency signal can be enabled at any time, regardless of ignition...It's too easy to do...
If done in the full version — it would be lovely.
Mail1977
I honestly got a little PM asking them to thank you and the hazard lights with one button)))
If the Tignes 2313 to replace 4313 sort of memory twice and can be done...But in the button of the alarm system to make a separate device"one button two devices even easier...
Yet such a proposal was received that the emergency signal can be enabled at any time, regardless of ignition...It's too easy to do...
I wonder why people in one button, I do not understand. I suppose it is more convenient separately. As the button of the alarm system inconveniently located, and to lay on thanks, need to look at it to find. And I thanks button led on the right hand stalk and do not look very comfortable
Interesting...I Have no such effect.Blink three days for the sample.(left on the trial and forgot.I remembered and went off on a 4 day))Everything was fine.
I will certainly look into the firmware.Just don't remember how things are there.But this weird glitch is that from clocking may occur, but why?
turned off the ignition
include flashlights until the led on the Board did not have time to go out (15 second interval)
hazard lights hammer, and over time, the flashing slows down a bit, after a few moments
Mail1977
I honestly got a little PM asking them to thank you and the hazard lights with one button)))
If the Tignes 2313 to replace 4313 sort of memory twice and can be done...But in the button of the alarm system to make a separate device"one button two devices even easier...
Yet such a proposal was received that the emergency signal can be enabled at any time, regardless of ignition...It's too easy to do...
noticed that the flashing frequency of the alarm system floats with the time when we are in a 15 second interval had to press the button of the alarm system after the ignition is turned off.
on the last one .
aren't all the cars are flashing at any time by triple-a ?
"thank you + hazard lights with one button", is done using 1pc of deluhi + 1 diode + 1 capacitor. Turns the relay normally. Unclear desire make a fuss where everything is done in flight from the passive components.
do not tell me. today, the picture — on one side of the road Parking lateral near the Maghazi, on the other taxable along okupiruet at 100 meters, near one of the stops draughts tithing, includes the hazard lights, and start snot tears of joy meeting
and because the SDA does not like to abide by .
I almost died only 2 times used .
my car doesn't break, unlike jeeps of all sorts at intersections .
This device is made.Seems to be no sense just to turn on the hazard lights.But people for some reason, this time straining.Don't know why...
There the device is disconnected from the power supply and turn hurriedly the hazard lights will not work.It is the hazard lights work without the ignition, but when it's activated no later than 15 seconds after the ignition is turned off.
I honestly got a little PM asking them to thank you and the hazard lights with one button)))
If the Tignes 2313 to replace 4313 sort of memory twice and can be done...But in the button of the alarm system to make a separate device"one button two devices even easier...
Yet such a proposal was received that the emergency signal can be enabled at any time, regardless of ignition...It's too easy to do...
thank you)
now drew at the same size and returned the transistor, so that the dimensions were divided into two sides
thank you )
it is what it is
here it is necessary to choose between easy connectivity and functionality
But, I have one friend there two weeks went — do none of the rear lamp is not burned, while the cops have not braked for the fifth time (!) the post and say — "or right here fix it now or fuck the car towed, and you will right now find that a couple of days to close" )))
The most interesting — he's twice twist the wires could not, and then fixed it for a couple of hours )))
There was a case once, when he refused both bulbs stops, but the extra stop at least worked.
now check
A. You are a good person. )))
Because I know no one light bulb at all does not check, yet they do not say that is not lit )))
himiks
thank you )
here it was necessary to help the person and to build a multifunctional device that could replace the standard relay to first was put in place of conventional bulbs — led turn signals.
It is known that if one lamp burns out in the corners, the flashing frequency is changed in a big way. So if you put led bulbs in regular relay frequency is not necessary. In General, without any alteration of the regular relay will not work... Load Svetikov not the same...
And then no matter what bulb...
The regular relay is easy to damage, it has ceased to control the load (health lamps), plenty of descriptions in the Internet.
However, with normal led lamps any regular relay works fine and so simply do not need to buy a bad low-power lamps.
Yes, even the ballast resistors to hang — and it's better than ruining the regular relay. Not a lamp, so at least wiring will control.
A lack of such control is very bad.
That person you how often checks the condition of the lamps? I — dimensions, the lighting of the rooms and turn signals check each morning (good snap, two buttons Yes, poked around the car bypassed), foot — once a week, because it is without an assistant it is inconvenient to do so.
and you do not think that the frequency is not just changing, but in order to learn about blown indicator, which is a pretty dangerous thing
thank you )
here it was necessary to help the person and to build a multifunctional device that could replace the standard relay to first was put in place of conventional bulbs — led turn signals.
It is known that if one lamp burns out in the corners, the flashing frequency is changed in a big way. So if you put led bulbs in regular relay frequency is not necessary. In General, without any alteration of the regular relay will not work... Load Svetikov not the same...
And then no matter what bulb...
Work great!
I think that the device is not complex in terms of manufacturing as in different functions.
On attiny13 the best option.
cherepok-nn
Very cool device! Not enough of one.
Like the idea of expanding the functionality to do the flashing of the alarm system in SOS mode.
...---...
This will help to identify and to help really need it.
be realistic: do You know many people who know Morse code?
well will see uneven flashing emergency gang, shrug their shoulders "buggy man of the electrician" and all.
with this functionality and microcontroller device is not being finalized. The memory MK is used at 100 percent.
if you do, then on another microcontroller, and this is a new device
Very cool device! Not enough of one.
Like the idea of expanding the functionality to do the flashing of the alarm system in SOS mode.
...---...
This will help to identify and to help really need it.
:) Cool project... Working on necrophorum. But a little in his bed :) delay_ms How many exposed?
hi
it is necessary to "smoke" how the twists and turns in the prior.
you know how, switched from the steering column stalk minus.
here is www.drive2.ru/l/5738912/
there you can click to configure the number of lengthening for your car.
there is no thanks button, well, if you change to a led lamp, the flashing frequency is too high for led lamps.
Hello, and prior to offer so that: the led lamp to put, the rotation is not complete switching-three times margola and hazard lights thank you natural?!
you have a circuit-switched red.
From here, information learned avto-shema.ru/index/reno_logan/0-231
it is the scheme turns here: avto-shema.ru/_si/1/84585443.jpg
cabin comfort pack www.logan-club.ru/forum/viewtopic.php?f=97&t=45630
performs the function turns the relay you have.
this device that in the post, suitable for any car, just in each particular case will be connection on the.