Autionary 2 version.
I have a blog entry about autionary is its advanced version. Did for a friend (work colleague). 50x50 LEDs — 20pcs. MK тини13.
Scheme.
PCB for Assembly.
Works as follows : when power is applied the red led lights up, which signals us that the food at MK is filed. This tells us and the device issuing a short flash on each power supply.
Then power stabiliziruemost to an acceptable MK 5 volts. MK generates the PWM signal on channel N key. When drawing diagrams made a mistake (hanging the key is not on channel OC0), because we have a software PWM with a frequency of about 140 Hz (9600000/255/255) (frequency MK/ overflow timer/ counter PWM).
Can auto turn off in 10, 20, 30 minutes and not switch off at all. (the video shows how programmable)
Further, when pressing the brightness increases when re decreases.
At maximum and minimum brightness with outbreaks of different frequencies.
When programming, change only the youngest f'yuz : 0x7A, senior default 0xFF.
himiks
Where such a shrink wide took?
I'm only 16 and 20 mm met
ru.aliexpress.com/wholesa...1%D0%B0%D0%B4%D0%BA%D0%B0
neodymium magnets a few pieces under the heat shrink on the back side would be nice. I carrying their mandatory mold)
make a detailed photo of the guts. Let's see what there is and what it can do. Maybe the fault is trifling, and it is quite real to restore, using the method of "abortion on the phone" :=)
Good afternoon. Need help, willing to pay. I have lights Dectance ( Ala tuning vag). And I have stopped it burning, in my record it is. Could you make this whole Pribluda, for money of course? There are a lot of resistors and a healthy Kander
that's awesome! super flashlight! cost is definitely can compete with the chinks! need to produce and sell!
"what for all the bells and whistles at the zoo?"
of course, I understand that training is getting your hands to create us in to the MCU
but in real life, these service bells and whistles nafig not needed. It would be better to make a switching current regulator, and get rid of the resistors to dissipate about 45% power on them.
If the pen test, then test.
And so, and 5050 is not in fashion and not very rational nutrition.
IMHO, 56(7)30 driver PT4115, which can be and MC to manage through a voltage divider.
will burn all the LEDs. even the factory say Audi's mercs too eager. not seen that. so you can put anything, but knowing exactly not for long)
I don't understand this, the question is, if you take a tape diode, cut into strips three diodes on each (just there are markings for cutting with scissors), to connect in series for installation in tail lights. Or solder it cuts into standard bases, to make let's say diode lamps! So what can be done? Burn out will happen? Or additional that you need to solder, transistor resistor not sure?
Because not spread, the man who is far from MK sources to watch will not. And who on the contrary is friends with MK he izhodna such prostatique thing is not interesting. Moreover, I am not a super coder, the source can spread to other neighing.
You are so all iMates about the source, I don't think there is a super cool development for you to register the copyright.