Replacing ATF __АКПП - Toyota Ipsum, 2.0 l., 1999

Action plan:
We take a basin or a container with a wide neck, tools - unscrew the nuts (10, 14 may still be needed), a bottle of gasoline

(2 liters of eyes), cloths for wiping must be lint-free, well, what thread for hands, if there is a medium-sized brush,

, then you need an attachment with which to fill in new oil (it is poured through a dipstick) like a funnel, before removing and unscrewing everything, you need to make sure that it will be convenient to fill with it, oil canisters that have a funnel-type nose, for example, Castrol ... Clothes should be appropriate and what kind of thread should be attached to the head :)
We take out the probe. And fill it in

We drive the box for 10 minutes and into the pit.
Unscrew the drain plug

waiting for the oil to drain. If you want, you can jack up the car so that the slope is on the plug and maximum oil drains out.
We tighten the plug and unscrew the bolts

around the perimeter. everything, except 3-4 pieces, so that the lid does not fall when we tear it off. we twist these 3-4 in half.
Take a powerful flat screwdriver or something more convenient and tear off the drip pan. There is still oil and you need to try not to spill it on yourself.

We remember where the magnets were, take out, wipe them with a rag and stick where the thread is in a prominent place, rinse the pallet with gasoline

, remove the filter from the box - three bolts.

the filter also contains residual oil, so be careful when unscrewing it. ... We wipe the pallet with a dry, lint-free cloth - no lint should remain. Degrease the surface
Install the filter. We take the magnets and put them as they lay in the pallet.
We carefully fold the pallet and the gasket with the help of 2-3 guide bolts around the perimeter, put it in place, then tighten all the other bolts.
Then we fill in new oil approximately as much as it has poured out.

7) We start, we run the box according to the positions - we check the level without being muffled, it must correspond to the COOL level.
Let's go for a drive. On different modes of the box, 5 minutes will be enough. Drain the oil again (without removing the pan, but only the bolt)
Fill in a new one
Repeat 2 more times. In total, we drain 4 times and fill in 4 times. And the first time, tk. unscrew the pallet, drain the 3 liters, at other times by 2.
In total, it will take 3 + 2 + 2 + 2 liters for a total of about 9 liters.
After all the changes, every day we check the oil level for hot. And top up if necessary. Well, we monitor the pallet leak for a couple of weeks - it should not be. If there is, then remove the pallet and do it all over again :) Like everything ...

Price tag: 3 000 ₽