Trouble Happened - Toyota Sprinter Marino, 1.8 L, 1993

WHAT GUYS HAPPENED A NEGATIVE PIECE
Yesterday I went to the garage, put painted turn signals, started the car, drove off ... I drove out
onto the highway, everyone was blinking))) I realized that the headlights had to be adjusted, drove into the woods, twirled, like I lowered the left headlight, but for some reason the right one was not lowered , but stupidly either up or to the side, but in short, I sent it to the right to shine ...
I drive back onto the highway, I drive 200 meters, and I see something mega on the right, then in the garage I determined that the light bulb burned out, but it burned out before the end ))) and megalo ...

But the trouble befell me a little further, along the highway ...

I stopped to turn right, I saw there were no cars, I turned, and GAS ... And the car once and STUNNED ... well, I think, that's it, I arrived ... I start the car, and it barely barely starts, but it started. The turnover is stable. I press slowly on the gas, the speed rises normally, PRESS sharply, it chokes and the CHECK megaets. Vopschem how I got home, the car does not want to not how to go. It was about 3 kilometers to the house, during these three kilometers the tank was empty by about 3 liters))), the arrow of gasoline just went down before our eyes ...

Deduischiy day ...
Vopschem half a day in the garage)))
I remove the cover of the distributor, and there all the contacts are like OXIDIZED, cleaned, started, did not gas, let the car warm up ... I turn on the back and halfway out of the garage the car stalls, somehow started, just get under way it stalls again ... I
went to remove the distributor again, I took it off and there was moisture ... just small droplets all over the lid inside ...
WHERE I wiped it, started it, left the garage, drove it backwards, just had to look into the hole in the boot of the CV joint ... how about the car began to obey the pedal gas and briskly so ... after a couple of hours started, and again the same story, stupid and that's it ...

By the way, I made a float, managed to shove a piece of pinoplast under the old one ...

PS And finally the anther is a kick-ass