How I did the trunk) - Toyota Cresta, 2.5 L, 1994
First day.
I wrote a new disc in a wheelbarrow.
And the whole day behind the wheel.
I took some pictures.
I bought the material, tomorrow I will do the floor in the trunk.
I think it will turn out very well!
And you can happily look into the trunk!
How do I check it out!
Second day.
Well, that's almost all!
The floor is measured, sawn out, modified, and now it is already glued to the fabric ...
To make it look more beautiful!
I'll put it in the trunk tomorrow. And I'll post the final photos.
But for now, here's what it is!
Day three.
Paved the floor in the trunk.
Washed inside and outside (free).
I glued the LED on the hood.
I put a light bulb on the back room lighting.
And the car looked even better.
Mileage: 227,383 km
Then I'll fit others on top! But so far ...
I did what was at hand.
I still have a fabric rug on top))
So that it doesn't get dirty too much.
I didn't first mark it with a tape measure, then cut it roughly, then adjusted it in place) I
glued Titan on glue, and Moment. But you can do it for anyone, just what I was, I glued it.
I didn't spend it on the floor at all, not a ruble)
The only thing that needs to be redone is the central part, it came to me only after I had done everything. It is necessary to saw off the distant piece of the central part, approximately in the place where the side parts reach. Then it will be easier to pull it out.
I didn’t do it on hinges, my carpet fulfills this function. Less noise) There are plans to put a subwoofer, but for this you need to glue everything with Shumka, and tighten the entire trim)