Do it yourself - Replacing the fuel filter - Toyota Corolla, 1.6 L, 2002

Finally, I am ready to write an article about replacing the fuel filter, I really didn’t take enough pictures, so I will use pictures from the Internet. I thank in advance everyone who took these pictures.
------------------
Purchasing
------------------
It is necessary to purchase a fine fuel filter, I took a non-original SCT. Nobody buys a mesh (coarse filter), it almost does not clog. The price of a non-original fine filter is around 400 rubles.
------------------
Getting started
------------------
To get to the filter you need to remove the rear seat. To do this, you need to unscrew 2 bolts in the corners, and pull the seat out of the car, it keeps on latches.

Having done all the manipulations with the seat, we get the following picture.

We remove any debris that has accumulated under the seat, disconnect the positive terminal of the battery and open the lid (it rests on a plasticine sealant and can be removed without problems with a thin flat screwdriver).

We wipe the "Russian-Japanese" dust and disconnect the pipes.

This branch pipe is removed very tensely. It is necessary to very carefully pry off the two latches marked in the figure from the inside, since they simply did not want to be removed by pressing on both sides.

We take out the plug, and carefully take out the hose, attaching it with some kind of rag (a little gasoline will pour out). We make a mark on the case in order to later install the device in the same position. In this case, it's a drop of paint, I just made a notch. We unscrew all the bolts in a circle and take out the unit. The resulting hole in the gas tank must be covered with something clean so that the interior does not get blown out by gasoline and so that nothing gets into the gas tank.

It is easy to understand. Everything is fastened with latches. Be careful not to break anything or bend the float. We get the following:

We clean the mesh and assemble everything in the reverse order.

We get the following result.
----------
Important
----------
Unforgettable to install all rubber bands. Rub them so that everything is very tight, if necessary, hold the rubber bands in boiling water so that they soften a little. If you do not put all the rubber bands or install them without rubbing, the car will not start in the morning from 1 time. Do not bother too much, just collect everything neatly so that everything fits right and everything will be fine.

All! You can start a car. It will not start immediately, but the second time. Do not be alarmed, this is gasoline pumped through a new filter.

We continue to drive with the saved 1500 rubles - that is how much it costs to replace the fuel filter in Volgograd, a neat approach and cleaning in the cabin are not included in the work :).