Bite...
My fun with the Chord
over this
and that's it
Shattered the thrust bearing of the tower, had to change it
Then cleaned the spar with a shield of the engine compartment, and only then finally was able to hold on front rack, restoring the geometry of the doorway.
The following stuff - if you strike marked the subframe
He began to chew donor... Foul thing - drill out spot welds on thick metal with high-strength steel...
The hand slowly moves in continuous corn, and before the end... as far as money for this work.
With malnutrition took the bumper from Carrera brewing — to remove the holes from the lights under the enemy's number.
I like that one person a picture of Cracovia promised - I hope he will help in the search. This from the Whale. Quite comfortable and a hole punch are. But expensive - I think about three thousand for it gave
And lastly - a lot has already been prepared for a wide announcing my Club slowly filled the club website. I plan to seriously address this this Sunday.
Today, my repairs put the car specialist in the creation and promotion of brands.
He really liked the design of our office, I showed him the card ( just last night got).
He thinks that done on a good level and is willing to give me advice on promoting this idea.
I in body repair is very Amateur, but for me it would be easier for Honda to change the entire body)))
For example www.drive2.ru/r/bmw/1225533/ here, you have a little wing in place to move, literally 0.5 cm, a control point is.
cromogen is also now looking for this know — such as in the photo from 4000 rubles in the online store, litovski 4600 or so, for such money it is already possible to watch pneumatic — litovski Oklo 6000 (with hole punch)
and just note that there are Voronezh production flanging, cost about 800 rubles, but on such sites the order of 2-5K (what, how)