State of emergency with a brick from a seignalka ... - Toyota Corolla, 1.6 liter, 2006
I dropped a shave from the alarm shyrkhan of all that is somehow not with a private meter ... and broke the screen that shows everything and the temperature and whether it is closed or not, they steal or hit the wheel or hit me ... 7 minutes.
back.
The new one costs 2500 + 1000 firmware for my car ...
WHAT to do!
turbidity under warranty)) to give on the paw just a bit, if the warranty is over, then the new filling is in the region of 1t.r. you can try it there yourself)
They put it to me in the insurance company and they say that only buying a new shave ...
PROGRAMMING NEW KEYFOBS
The system can memorize the codes of three keyfobs. To start
programming, the system must be disarmed using the
key fob or emergency using the PIN1 ignition lock, or using
the PIN2 call sensor. Also on the keyfob being recorded, the
Hands Free function must be disabled. To program new
key fobs, follow four steps:
1) Within 4 seconds, turn the key in the ignition lock three times from
the OFF position to the ON position.
The alarm will flash once to confirm the
first step. With PIN1 off, go to STEP 4
2) No later than 4 sec. after flashing alarm
turn on the ignition. The number of clicks when switching on corresponds to the
first digit of the personal code (factory value "1"). The
alarm will flash once, confirming the readiness to enter the
second digit
3) Not later than 4 sec. after the flash of the alarm, switch on the
ignition. The number of clicks when switching on corresponds to the second
digit of the personal code (factory value "1"). The alarm
will flash once, confirming the readiness to enter the key fob code
4) No later than 4 seconds. after the flashing of the alarm, shortly
press the button "I" of the key fob, the code of which must be entered into the memory of the
processor unit. With an interval of no more than 4 seconds, you can
press the "I" buttons of the three remote controls, then the system will remember their codes. If
it is necessary to write down the code of only one
remote control, then shortly press the "I" button of this remote control three times.
To exit the programming mode, do not take any
action for 4 seconds. after writing the code of the last keyfob.
Two flashes of the alarm will follow, confirming the exit
from the keyfob codes programming mode
Note:
The system has three memory cells for storing keyfob codes. If you
try to record the fourth keyfob, the code of the first recorded keyfob
will be deleted.
In 2 minutes, I and a friend, whom he knew, asked for a new key fob to his car, I don't know how on a sherkhan on a tomahawk, the instructions are detailed.
All currents to buy a new keychain due to one blow from the asphalt from one meter = X