Sketches ... - Toyota Corolla, 1.6 liter, 2007

Really quite! But there are no more stubs (((

hi =) Looks very original, I liked it. And if you run the diodes along the edge of the plug around the entire perimeter?

I had a large tape, and I removed the LEDs and resistances from it and soldered everything in the same way.

I really liked the idea with daytime lights. The same must be done, soon after all in the city or with them, or with a neighbor. Another question, soldered resistance, or not, if so, what?

Thank you so much! Good luck on the road!

Sent it!

[email protected]

throw your soap, I'll send pictures.

looks beautiful! I would be grateful if you could describe in more detail the processes of LED packs!

Thank you)) I tried.

Simpotichno))) Original)) well done)))

Sori, I didn't take a picture. In fact, there is no process, you just solder 3 LEDs and a resistor and so I got a mesh)) look at how any LED strips are soldered and you will understand, the MAIN IMPORTANT is that everything does not burn out to power the entire circuit through the stabilizer! Well, seal everything, because the place is quite "wet".
If there were pictures, then they are no longer there ((ask Bart56 to whom I threw off, maybe he still has.

It turned out beautifully)
Well done !

Couldn't I also throw off the spike process, if it's not difficult, thanks for earlier)
[email protected]

Thank you)

[email protected] and throw me off too please