squeaky pads ^^ - Toyota Celica, 2.0L, 1991

Almost from the very beginning, purchases creaked brakes, and when, sometimes barely audible, and sometimes even squeal is unbearable!
as a result, Nishinbo pads were purchased on the front and back) and Liquid Molly brake)

and since this time the garage turned out to be free, I did it myself) despite the fact that Alteza was in the garage itself and a friend also changed the pads in a circle, Sprinter and Fielder stood next to them in the form of spectators :)

and I stood in front of the garage, and proceeded to replace the left front, as I thought the guides were dead (at the same time I took them off, scrubbed them with sandpaper from rust and smeared them), the anthers turned out to be full of holes (just like my socks :) but while I left them, others no.

at which I had to tinker with pressing the cylinder under the new shoes (but with simple movements everything fell into place)

with the rear on the same side it was easier, and the cylinder was smaller) and wrung out almost from the hand) well, the guides were also lubricated) and otrainny)

all the same was done on the rear right wheel) without any problems)

but with the front right one had to tinker a lot, one of the guides finally did not move stupidly, even with the help of a hammer (I had to fill in the vedehu, and knock out again with a hammer, they moved them from their place, but while they knocked them out, they flared both sides. and I also had to work with a file in the hole)
but then XD enters and exits
well, and again fiddled with pressing the cylinder.

in the end, it took the whole day to replace only the pads in a circle!)

but it was worth it :) the pumping of the brakes was postponed to another day) that bi continuous ...