Torpedo sizing — logbook Toyota Corolla 2007

There was free time and a desire to glue the torpedo. Madeleine was bought in advance. I didn’t make a full photo report. I’ll just say that the whole muzzle is disassembled by hand without any attachments, everything is simple and accessible. A Phillips screwdriver may be required 2 times.
1- removal of the control unit (where the heating buttons are)
2- removal of the upper glove compartment

A week ago I tried to glue the plastic contact points with strips, but oddly enough, I did not get the desired result. Yesterday I tore off almost everything and glued it using a different method, according to the photo below, I think everything should be clear

Here is such an LED in the upper glove box, as I saw it, I even felt sorry for it)) how tiny it is))) and the light from it is some kind of orange ...
Along the way, I replaced it with a more powerful one, now it’s enough. (I think it’s stupid to glue LED strips into it! Why ?!)

Let me explain as an example so that there are no questions:
* this is the right upper part of the torpedo
* the front pillar lining is inserted into it

A strip of Madeleine is glued on the left side, you also need to glue these 2 rectangular holes from all four faces and that's it))

The work is not difficult but tedious, because pieces of modelin had to be glued small. Big ones don't make any sense!

Satisfied with the result!