Installing the gearbox in place - logbook Toyota Soarer 1990

The antifreeze leak haunted me, I wondered for a long time where it was going until I accidentally noticed a leak under the car. Opening the hood, I saw that behind the block there is a cover with 2 fittings. who go to the stove, that's where it flowed. and it was already flowing like a stream. Because access to this place is difficult, and for repairs it was necessary either to remove the turbines, which I already did, or the gearbox. Because I didn’t touch the box, but they didn’t put it at the factory, it was decided to remove the gearbox, at the same time I’ll change the seals. When removing it, it turned out that several bolts were missing, when the clutch pedal was pressed, a creak was emitted in the area of ​​u200bu200bthe basket.
When removed, it turned out that the cover gasket was leaking, but as it turned out later, not only she. So, having removed the box, the first step was to wash it, because. she was very dirty, then start to change the seals and put on Sorik.
So, the seals are changed, we fasten the bell

. And here is the gearbox itself.

.
The plugs were made from improvised means, in this case, gloves.

We clean the input shaft of the box from any dirt

.
There we have to lower the checkpoint and climb ourselves.

Because the release would have been filmed, we decided to capture it, the release was modified with an insert instead of a catalyst

Photo with box

Installing the exhaust pipe bracket

Everything is clean, now you can collect further

So, we have a release bearing, a gearshift fork, we clean it again and carefully lubricate it with grease.

,

,

,

Fork assembly with release bearing

Already assembled with box

.
The place where we are going to install

,
and here is the culprit of this epic, screwed on two bolts

One turns the bolts

, the other supports the hard box

During the assembly process, it was not easy, the photo shows a tool assembled with extension cords and a cardan, which had to be used repeatedly

.
In general, everything is ready, it remains to collect a little in the cabin and we will be happy, we still need to fill in the oil)
As it turned out later, the leak remained, but it became much smaller, apparently we will have to change the nozzles.