Backlight Part 1. — logbook Toyota Corolla 2007
Soldered and set the backlight legs.
Bulb diameter: 10mm Light
color: Blue
Lens: Oval, transparent
Light intensity: 8280-10750mcd Light
angle: 25 degrees
Current consumption: 20mA
Operating voltage: from 2.8V to 3.6V
Power consumption: 80mW
in order to achieve a scattering effect on emery, I sawed off the lens and carefully finished it with a fine sandpaper.
The brightness dropped by 50 percent, but achieved a uniform light.
The cost of one, including shipping 4r.
I picked up a resistor for them:
470 Ohm
0.24 W
www.casemods.ru/services/raschet_rezistora.html
Resistors for the ruble.
2 strips of 12 pieces. The cost of the project = 120 rubles.
Issue price: 120 ₽
To be honest, a lot of unnecessary crap with this bar! It is much easier to use a diode tape, they will be more durable) But this is purely my opinion)
We sell LED strip in the market in different colors. 72 cm of this tape will cost 200 rubles. There are also LED ones, as it were ... well, I don’t know how to say ... tubes or something. specially for such purposes, it costs a little more, but is easier to install.
It turned out nice. Hooked on opening doors?
yes, it was powered from the limit switches on the doors) I like the manufacturing process itself, and the result is more than I like others)