Shumka. Beginning… — Toyota Corolla Levin, 1.6 liter, 1999
While the repairman was unwell and the fit and installation of the bumper hung up, he finally decided to do the Shumkov. Summer is coming to an end, you have to keep up.
On Saturday, the sutra bought materials, got to the garage and started. The remaining half of Saturday for work was spent mostly on disassembly
at the end of which he managed to roll up only 1 small section of the floor with a bimast
I tore off the regular Shumka, where it was peeling off ...
On Sunday, things went faster, but the weather soon deteriorated, the sun hid, and again I had to heat the bimast with a hairdryer before gluing. As a result, the entire floor to the rear sofa is rolled up with bimast
While on the vibra, I stopped there, I decided to first make a full sound of what lies under the carpet, so that I could lay the carpet, assemble the panel and put 1 chair, and not mount it, dismantle it daily, and then deal with the back part. I started to glue a layer of twiplen, but, unfortunately, I managed to do a little, about half, and actually, this is how I drive now :)
Until the weekend, if the weather calls, after work I will continue little by little. Hope to finish next weekend...
I, too, have been planning everything since spring, but I couldn’t decide in any way ... and then it’s up to winter, soon it will be a loud (very loud!) Amtel change of shoes ... I can’t stand the second winter under a rumble comparable to a Boeing)
Tower!
For the fact that my hands are taken at all - I can’t set myself up for this, well, I can’t :)
xs) people write how wonderfully they manage to do everything in 2 days, and in two days I did no more than 30-40% of the work) with twip it is much easier than with bimast, soft, it bends and rolls easily, but there is still a lot to glue with bimast) and the places are more difficult than the floor in front) in general, I’m still afraid to even think about how I will glue further with a bimast)
and by the way, it’s not in vain that special offices sell narrow rollers with a metal head for 500r, I didn’t think in advance - due to the mass, it would be many times simpler…