Well, here we go! First recording ! — Toyota Celica, 1.8 liter, 2002

Having seen enough photos of high air intakes, we decided to create them ourselves, especially since the hands seem to be growing from the right place.
It was purchased:
Masking tape
Food Film
Finishing and rough with fiberglass putty
Epoxy resin
8 meters fiberglass
sculptural plastelin
Sandpaper
Gypsum filler
Pile gaziroffki + pyvo

And so what they did:
We stick around the hood with masking tape + cling film!
We raise the air intake by 2-3 cm and fix it firmly to the hood.
Next, from plasticine, we sculpt a new air intake directly according to ours.
Cut off the excess with a knife.
Most importantly, the better you make the layout, the better the matrix will be!
The first time we failed, we decided to make a plaster matrix, after waiting 2 hours, he did not even think to set.
We decided to break everything down and remove the fiberglass and fiber matrix.
To do this, cut into small pieces of fiberglass!
Do not try to knead a lot, it is better to do it in steps and not much.
The separating layer was a polish and cling film.
Next, they removed the matrix, brought it to the ideal with putty, and filled everything with resin and fiberglass.
Tomorrow will separate the product from the matrix)))) fingers crossed)

Well, also thanks for the help and assistance in this project to two wonderful people, Max seleron74rus and Vitalik SClub, as well as our fearless Levin pilot Ruslan!