Seat Belt Mute - Toyota Mark X, 2.5L, 2004
Method 1 (it worked for me)
------------------------------------------- -------------------------------------------------- -
So, to turn off the nada saw:
1.Convert the odometer to Trip1 or TRIP2.
2. Turn off the ignition
3. Turn on the ignition (but do not start the engine)
3. Change from Trip to ODO.
4. turn off the ignition
5. turn on the ignition
6. Press and hold the TRIp / ODO switch button, but no later than 8-10 seconds after turning on the ignition. Without releasing the button, wait until the "fasten your seat belt" light flashes 20 times ... then fasten your seat belt ... (without releasing the button). and after a few seconds, the beep off mode will appear on the odometer display. -
switch to OFF by pressing the same button and you're done 7. turn off the ignition
ftp://club-lexus.ru/incoming/FAQfiles/en_dpl950vd.pdf
thanks to the site www.club-lexus.ru
-------------------------------------------------- --------------------------------------------
Method 2 (did not work for me)
-------------------------------------------------- --------------------------------------------
Original method in English
Our ignition key hole has 4 detents
In clockwise direction (see figure above)
0 - LOCK
I - ACC
II –ON
III - START
1. Insert key and turn to ON (II), then press the ODO button and hold. Make sure you see the
ODO and not the trip A or trip B.
2. Pull out the key completely from the lock and then release the ODO button
3. Insert key and turn to ON (II) and then press the ODO button> 10 seconds.
4. While pressing the ODO button with the left hand, use right hand to insert the seat belt
Buckle.
5. The b-on / b-off will appear. Press and release the ODO button to select the desired function.
Then take your left hand off the ODO button
6. Pull out the key completely from the lock and un-buckle the seat belt
7. Process complete.
-------------------------------------------------- --------------------------------------------
Translation using school course skills) ))
The ignition switch has 4 positions.
Following a clockwise direction
0 - LOCK
I - ACC
II - ON
III - START
We perform the following actions:
1. Insert the key into the ignition and turn it to ON (II), then press the ODO button and hold it. Make sure you see the ODO on the display screen and not TRIP A or TRIP B.
2. Pull the key completely out of the ignition and then release the ODO button.
3 Insert the key into the ignition switch and turn it to ON (II) and then hold the ODO button for more than 10 seconds.
4. While pressing the ODO button with your left hand, use your right hand to insert the seat belt buckle.
5. The b-on / b-off mode selection appears. (as I understand it is Beep (signal), the state is on (ON) or off, the state (OFF)) Use the ODO button to select the state.
6 Pull the key completely out of the ignition and unfasten the seat belt.
7. The process is complete!
Disadvantages, I figure it out only when I don't like the content of the message ...
And yet, the threat of a fine, and not the instinct of self-preservation forces you to fasten the belt ...
And the laptop in my trunk goes, and you won't believe it, where I fasten it so that it would not dangle around the trunk.
What an instinct for self-preservation - here people buy a right-hand drive for a lot of money, they are also happy that the signal of unfastened seat belts can be turned off - double insanity, and you mean self-preservation ...
Disadvantages, I figure it out only when I don't like the content of the message ...
And yet, the threat of a fine, and not the instinct of self-preservation forces you to fasten the belt ...
And the laptop in my trunk goes, and you won't believe it, where I fasten it so that it would not dangle around the trunk.
you are respected for driving without belts ... if I understand correctly?
God help
me , I hope with the head-on, flying out through the glass you won't hurt anyone ... you
will agree it would be a shame to be knocked out of the car by a body just because the body was not fastened ...
Are you so offended in life that you figure out the cons? Yes, I chhal on your cons!
I always wear my seat belt, it's a pity to pay 500 rubles of fines. I talked about the laptop! I think the signal should be 2-3 times and not blow up the brain for as long as 5 seconds!
you are respected for driving without belts ... if I understand correctly?
God help
me , I hope with the head-on, flying out through the glass you won't hurt anyone ... you
will agree it would be a shame to be knocked out of the car by a body just because the body was not fastened ...
Thank God I have such a signal and I do not need to turn it off. I always wear my seat belt ...
Chilis, And if you lay down a laptop, then you fasten it too?
Thank God I have such a signal and I do not need to turn it off. I always wear my seat belt ...
How complicated it is)
Thank God I don’t have such a signal in the aster, but the Lancer has it, it pretty much on the nerves presses, the car is not mine, but I would make it easier) 2 wires go to the lock, well, why don't we Russians reflash the brain of the whole car in order to deceive brainy Japanese, you can short-circuit these two wires)
Why climb somewhere and close something ?! if the Yapas themselves left the option to turn it off, except for the blinking of a person with a belt, this problem is no longer annoying.
I always wear my seatbelt! But when you go 20 km / h in a traffic jam (i.e. when you can relax and lie back in the seat, naturally unfastening your belt), this garbage is really annoying!
I tried the second method on the Corolla - I disconnected! Thanks to the author!