6 reasons why the car did not drive - Toyota Corolla Levin, 1.6 liter, 1994

Today the assembly of the motor is completed, other people did the editing of the saddles, because. it was not possible to make a tool that I could use on the 4A-GE 20V, I didn’t do the lapping of the valves - I just ground the valves to the factory 44.5 degrees ...

For the entire assembly time, the reasons for which the car did not go for me were discovered (and others said that it almost flies - they were pressed so hard into the seat)))))
1. Very dirty intake - less air, and everything else ...
2. Too large valve clearances - small lift and width of the valve opening phase ...
3. Gas erosion (shells) on the valves and saddles
... 30 p / synthetics)
5. Clutch ground off almost into the trash (at the time of purchase and before disassembling the engine it worked the same way) - slipping under heavy load - loss of power ...
6. Dead lower engine mounts - the result of a dead box (+ clutch helped her drive off to another world), which died gradually and clearly began to do this even under the previous owner ...