Bodywork, let's start ... - Toyota Celica, 1.8 liter, 1989
Since things are still tight with the engine and with wiring, I decided to do something that definitely wouldn’t make it worse, took off the front fenders, you’ll see how bad everything is
The lower part is full of atas, there is no metal, the top is whole and does not threaten anything, he began to clean it and immediately stopped, there is no metal at the bottom u003d holes appear almost immediately. put the cleaning aside, tomorrow I will put everything in place, I will start cursing the body kit, and for one wing with the extension, until it completely fell apart ... alas and ah ...
UPD:
prepared surface for sculpting.
the price of the issue indicates the cost of 2 rolls of a wide masking tape, not all of it was used)
UPD2: I'm
checking how the clay behaves, so far we'll have a good enough look further.
Issue price: 200 ₽
wheels are wheels, a body is a body, I have already looked at something, but I have my own development technology;) don’t worry, everything will be good
well, it’s always like this ... since the wings are rotten, then we make them wider from plastic))
By the way, I recommend that you first pick up wheels with a good reach and make an extension under them.
good advice, no doubt! but all the same, I will leave the native line of arches, and I will try to keep all the native lines.
Landing — pnevmno, looking for good options. But there is a basic choice.
All the same, I will join the council about the wheels)
Kse wings should be done when the wheels and landing have already been determined ...)))