More light! - Toyota Mark II, 1994
There were lights on the bumper, but to my surprise, they did not burn, only the turn signals burned.
Decided to fix this issue. I'm going to sj45 , without him being savvy and loving technology, I wouldn't have done anything.
We remove the lantern, look: from the turn signal to the lantern itself there is a tape with copper tracks. We successfully remove the tape.
We fasten the wires to the base.
In such an uncomplicated way, we bring the wires to the dimensions.
Here's what happened. Illumination angle is approximately 90°. Illuminated those areas where the headlights do not reach.
And a couple of photos for dessert :)
Issue price: 12 ₽
I was thinking, maybe first I had to check all the fuses ... :), and then pull the wires)
These are wrappers. They light up only when the headlights and turn signal of the corresponding side are on. I also always wanted to make them burn without a turn signal, but my hands never reached)
it was necessary to check the fuses, as you correctly noted! you hooked on additional bulbs from the dimensions, the wiring will heat up. I also did this on my previous Mark and after the rain (2 times) they burnt out the wiring that goes to the dimensions! I had to abandon this idea! so if the wiring under the hood smokes while driving, know why)) well, maybe this I just had some additional problems with it, but after I turned off these lamps, this never happened again!
Well done. I also want to do this so that they shine well. I always watch when I turn on the turn, the Japanese are handsome, they came up with a good idea