I remove extraneous vibrations and noises - Toyota Corolla Levin, 1.6 liter, 1998
There is simply no "Shumka" in Levin. It is completely absent, and since I value comfort, this “jamb†had to be corrected.
Started with doors. STP (vibration isolator) was already present there, but partially, and there was no talk of any SPLENE) As a result, the volume of the door had to act as a box for the speaker.
After sizing the doors — the sound in the car has changed, it became noticeable. The bass got deeper and stuff like that.
PS: there is one nuance, which cannot be eliminated. Be sure to stick a sheet of "Bitoplast" under the door trim (black paralonchik with a bituminous base), because. "splen" reptile in winter begins to creak disgustingly when rubbing against the skin.
The ceiling is also glued, but there are no photos (
I was always infuriated by the pebbles "under the arches" - we eliminate it, and at the same time we glue the bottom under the rear sofa and the rear fenders. Arches glued STP M1 in 2 layers. then splenitis 6 mm and "foam" turned out vibration-noise-heat insulation). The place where the fuel pump is located - you don’t need to glue it, I first glued it, then I got tired of tearing it off)
This is the so-called preparation for a good audio installation, to which hands and funds do not reach)
The rest of the floor will "make noise" in the summer.
The hood and trunk lids were also subjected to vibration isolation. Photo later.
Issue price: 5 000 ₽well done man! 8) I’m also going to do everything ... yes, I won’t allocate finances in any way))