Voltage RAM
I want to overclock RAM, but I can't find the option to adjust naprugi:GA-AX370 Gaming K3
The default voltage range of 1.2 v,when you turn the finished profile rises to 1.35 v.With the latest BIOS update that I put, the opportunity to raise the RAM frequency above 3000Мгц.Want to use it
If I put DRAM voltage 1.4 v,the DDR VOLTAGE is somehow still remains 1.2 v.In the screenshot it is 1.35 v,as included ready profile
If the option voltage channel RAM And I/ I put 1.4 v then it puts v 1.98
[Denis]
Did you try without raising the voltages? Usually the voltage is increased if after the crackdown began to work unstable.
All right, so be it I have is 1.360 v and next shows 1.2 v standard value. Better BIOS to write in English. Voltage channel RAM I would not touch I have this option to auto. Where the Dram voltage from auto to put on your tension
Spoiler
For manual overclocking XMP profile is not becoming, and put its frequency, timings and voltage too. And save the settings. And unless latest BIOSes give the acceleration? I think they mostly under 3000 the Riesen I stayed on the f32 BIOS. If just some corrections left.
Rolemanser
There will be no stability
John14b
Just when you enable XMP in my BIOS DDR voltage range is 1.35 v,but if I will throw off on a default and put the DRAM Voltage at 1.4 v,that is 1.2 v.As it should be?
I do at KHMR in the RAM do not touch, there is a ready profile.You what nurse?
In the latest BIOSes I have seen the possibility of increasing the frequency of RAM, had not only more 2993Мгц.
1.2 v it shows the default value. It is not active in the settings memory. I also should configure the multiplier 32 ie 3200 MHz and lower voltage 1.2 v but this setting is disabled, since it shows a default value memory. But in the voltage settings there is already a real voltage 1.360 v is normal. If the system is loaded normally, otherwise I would be at 3200 at 1.2 v the PC just wouldn't sterinol
[Denis]
weather, these programs will show) it shows a standard supply voltage of 1.2 v, i.e. in Hades just shows me the XMP profile 2400 1.2 v you have 3000mhz at 1.35. To focus better on the Dram Voltage in the BIOS. I b450m
Acceleration undervolting do not need another. RAM fix in dram voltage taken from technical specifications to memory .
John14b
That is, the voltage, is set manually, the program can not monitor?
An__ei
Both hands on undervolting.Only the first generation Riesen unlikely that, if the calculator offers a safe 1.39 v when 3200Мгц'Ah:
Spoiler
Don't know, maybe some show.
I don't remember such. The voltage on the memory and put looking in the BIOS. So, why to monitor it, just set the voltage and forget. The calculator draws 1.360 v stuck I put the frequency, timing , procODT and forgotten. I have the calculator draws stuff I don't use them it puts 19 timings. Although the memory runs at a lower with 16 18 18 18/38 3200mhz dual rank at 1.350 v rather than offers calculator. I just have 2200g and with built-in visuals Vega8 and tension a little more so I stuck 1.360 v