Cleaned the computer, no image
Cleaned the computer (removed the % and cleaned it from dust and put it back). After reconnecting all the wiring unit starts but no picture. Even cooler from percent odd turns (like jumping, stronger, weaker, stronger, weaker, by the repeating of Paterna).The mouse is not lit at all (no backlight, no laser), Claudia food goes, but the response seems not..
If you removed the CPU then check whether you put it back (usually in one corner of the CPU socket and there are triangles, they must match when installing).
benites
The CPU key it cannot properly install. Installed correctly) again did the whole procedure + has prepollical vidyuhi and added thermal paste - zero result.
[Denis]
Cooler with heatsink and the chip itself because it is stuck on the paste to the radiator.
The username is still Listed
describe in detail how you cleaned that were disconnected, etc., and then the options of what could happen, quite a lot (ranging from unplugged/badly connected wires and ending with a batted components)
Len4ik00N
Disconnect all wires from the cooler Mati, disconnect the radiator from the RADIATOR STUCK the CHIP DIRECTLY INTO THERMOPASTE, whereas the CLIP SOCKET was NOT OPENED(this is all I noticed here later). Have propylesosit and bone cleaned. Put in place. Have all the wires connected - not working.
Now (for the third time when I did, it opened the clamp socket and fixed the chip right) pulled the whole OP. (Integrated vidyuhi not). Launched without OP. Not working.
You Adil the battery.
Wait. Go to put.
The username is still Listed
The buzzer beeps anything? If it is not - you need to put and listen.
The username is still Listed
Judging by the description you have system on a very old AMD or Intel (if wrong correct me). Again take off the percent. and carefully check the legs that all was in place and was not bent; also check that the socket did not have anything extra (pieces of dust, the remnants of thermal paste, etc.).
Len4ik00N
Fully paraprotein and perechistili alcohol from the paste, all rearranged. Cooler now it's buzzing. But there is no image
The username is still Listed
Squeaker - speaker that plugs into the motherboard near the wires of the front panel of the system unit.
If there is no picture, but everything else is working, you need to look carefully at the monitor included in the output of the video card, or motherboard (even if embedded video is not, the output can be).
(at the same time to check whether you have connected the power to the graphics card, if any)
(just to try to first pull the video card, then the battery from the Board. Insert in reverse sequence)
KPOT1987
The output from the motherboard is, and of such a cable there..
Power vidyuhi not.
There is one extreme of the pin is torn off?
PS
No, not torn off. It should be so.
Put a new vidyuhi in place - works.
Ehhh. Inscrutable are the ways of Iron!