do not start a comp if enabled extra fan(((
Actually, the problem described above. Could you tell me the solution or reason please)Chieftec smart 550W PSU, Riesen 5 2600х, ддр4 8x2 RAM, MSI Radeon рх580 8GB, ссд240гб+ндд2тб (7200об) barakuda.
In the case of the default there are two cooler (120mm) with backlight for blowing (both throw one Molex), bought another one with backlight 120 on blowing (connected to the mother) and one 90mm blowing on the drives (it is also on the Molex).
and here's the problem: if the 90mm on the 12volt line is connected, the computer really thinks for a long time on the start screen and eventually will start without PDM, only SSD. If it plugged in on hot when the computer is turned on, then everything works OK until reboot, then the new. If 90mm to connect to 5 volts, the unresponsiveness of this kind is much less likely to appear, but still there.
BP like enough, acceleration was not engaged, the valve is so much power takes?
how do here?
Well, maybe not enough power on one of the lines, 12V or 9V. I would consider buying a more powerful PSU.
Vignoni
Try another valve. Can it great resistance (Shorty in the winding of a motor). Maybe the PSU has reached its limit capacity. Real capacity without measurements and test we still don't check.
So:
Valve or BP.
The elimination method will be visible even without the multimeter and other things.
Ryazancev
thanks for the prompt)
new BP if you take it just probably already to go and change, but still under warranty and 14-day period has not yet expired. Without a valve on the Molex works fine, but as soon as put on the Molex valve (tested 90mm and 120mm - the same) - does not start at all or starts with a huge delay (about 2-3min hangs on the launch image of the BIOS) and see CDM(
Vignoni
Oleksy themselves are fact. With them I advise you to be careful. It is unreliable connectors.
Can short on Molex (dad or mom) see for yourself.
You are lucky with PD. Would Aerocool VX, there would be Russian roulette, that will otgorit on the first, second and compote.
Ryazancev
damn, wanted to buy two more of the valve at the top of demand, for the full set, so to speak, and the mother only one 3пин in addition to the CPU, and one is already occupied( it is possible as-that to precontact them, or to score?
and if, in General, the PSU enough for this configuration? acceleration is not planned in principle
Vignoni
About the PSU it's hard to tell chenit intelligible. Even if you write the model and it will list the last recommendation. Sometimes a Marriage but like a marriage Malacca.
It is necessary to look.
The idea is to config your power supply should be enough. I usually recommend PSU of higher class with a stock by 30-40 percent. So that the efficiency was maximum (less surface noise) and to stabilize the (protection) worked fine, they need to stock.
Vignoni wrote:
Without a valve on the Molex it works fine
It is easy to check. Take the plug to this connector any more known-good device.
Ryazancev
Maybe marriage CDM?
Today started to make suspicious noises at startup and sometimes when the load on it, creaking,as if scratched something...
Vignoni
Look SMART. It is the Express diagnostics. The screws can do different sounds to publish even in good condition.
Right now the screws are also on the market are not all good. All state lottery. That was more or less - the price of a budget of approximately * 2 and guarantee 5 years.