Temperature after updating the video driver
The GTX 1060, put the driver 385.69,the temperature of the game increased by not many degrees on the previous driver this was not. Can the driver affect the temperature?Ryazancev
50 % revs at a temperature of 50-80 degrees, in the games 50 to 65,but I do not know.
InboxM
What kind of a 1060? They are different.
There are nepoymi-that with one small ventilatory, and have her Majesty asus rog strix, with three screws, which is no crap in any box will not cram.
I have, incidentally, is. Driver 385 is also recently updated. No change. No.
Strange all the same.. the Temperature when you enable 32°C,prior to this was a driver 381, with the inclusion of 22-24°C.
Still ask your question, could change drivers affect temperature?
InboxM wrote:
Strange all the same.. the Temperature when you enable 32°C,prior to this was a driver 381, with the inclusion of 22-24°C.
At this temperature, the cooler doesn't even work,it can come from many factors and conditions,ranging from the temperature in the casing and ending with the applications that you have running.
InboxM wrote:
Still ask your question, could change drivers affect temperature?
Unlikely,unless the driver has not changed the frequency or the algorithm of the cooler,but it's not likely the previous version of the driver to deliver and check.
saa0891
I will try of course to revert.
The bottom line is that cooler is configured through afterburner, setting the cooler I have not changed, for example in games load the map 60-75% on the old driver temperature 50-60 at 50% rpm of the cooler, the new driver all the same but the pace might be 60-70.It's very strange
Rolled back to driver 381.89, the temperature fell into place. Put 385.69 again a fever? This is what can be the matter? Put later versions such as parsley
InboxM
Look at the value of the min on new drivers,apparently the old driver you have a frequency lower than the new,because the card works in 2D mode.I have such a hat was on the old radiance 280х.One driver in 2D mode frequency was low,put newer frequency much things were,and temperature in simple.In simple you have to show the minimum value.
Spoiler
I have a problem the temperature rose to 46 degrees and the cooler raises the revs and after a few seconds resets. What to do?