Question on overclocking.
Hello, dear friends. I got a small question, to groping in terms of iron men. Hope for an adequate perception and your thoughts about...You have the following config:
Gigabyte GA-78LMT-S2 (mini itx)
AMD FX-6300 (3.5 GHz), (Vishera)
Spoiler
Cooler Zalman CNPS9700 NT
Kingston 8192 Mb DDR3 PC-10700 (667MHz)
Hyundai Electronics 4096 Mb DDR3 PC-10700 (667 MHz)
Spoiler
As you can see, the result is achieved by means of the acceleration of the bus from 200MHz to 240MHz and tweaked the CPU multiplier to 4080MHz frequency, memory frequency totaled 1599MHz. Energy saving utilities in the BIOS are disabled. The question is: such is the strange combination turned out to be because trying to overclock the CPU multiplier without touching the tire, above the 4GHz could not achieve (4.1 - screen of death). I tried not to touch the CPU and adjust the memory to 1600MHz, the BIOS resets the settings. Tried to increase the voltage to the bridge, the processor, the operational increased only the dissipation, the result did not change. Drove the bus up to 250MHz memory was 1666MHz, percent - 4165MHz like - some time in this regime a computer could exist and even allowed him to test some toys, but in the end, after an hour or two, a blue screen of death destroyed any hope.
I'm just wondering what's the catch: in my perverted-curves hands? Sometimes there is a feeling that the case in Mamma - well, budget it that much here, and strap-operatives, overclocking abilities, especially not equipped. Just know that my FX people and driven up to 4.5 GHz, and from my humble knowledge, there is information about what FX-s, robust design able to reach their potential, working in conjunction with the memory running from 1866MHz and above.
May be you have a couple of thoughts on this? That I can not do, can not understand why or do not know or still of such configs, no longer squeeze? Thanks in advance and good mood. =)
Vinni-Pukh
Raised. It is strange that I did on this motherboard that you can overclock.
KazymirZyba
KazymirZyba wrote:
Raised. It is strange that I did on this motherboard that you can overclock.
Sorry, what do you want from this Calloway nurse ? There are only 4 power phases...
About the bruise when overclocking via the multiplier - I had to enable Load Line control, I'm the same there. Turned on - the problem disappeared, the acceleration holds, the frequency drops.
seeing suffixes Gigabyte micro ATX can immediately notice that the Mat Board is shit and probably prevents the dispersal of
the same is to understand what, exactly, to disperse
if you drive that bus, then being chased by, for example, and the controller PCL-e video card that could destabilize the whole system out of Saitoti from the physical limit.
correct pitch in my opinion to drive this pitch with disabled turboboost (since this processor turbo frequency current into 2 sections (4 core)) which can lead to some Igor to the loss of fps odnako
to further enhance the fact that the NT-link to the maximum Mat Board. this as I understand it the couple like task scheduler
well, then Kukuruza to the limit for a pitch I think it's somewhere in the 4 GHz Rione
the second point is that memory is asymmetric so that with high probability there is no dual canola. and it is about -10% in games primerno at high frequencies but it is possible and therefore the dispersal of the corn goes on