Problems with the compatibility of different laths
There are 4 strips of RAM ddr2 at 800 MHz., 2 at 2 gig (samsung) and 2 1 GB (from an unknown manufacturer). After the recent change Mat. fees they refuse to work together, and instead of starting your computer you only hear the signals, and even before the BIOS doesn't come up. Before replacing and it is currently working together. It turns out that you can put either 2 dies on 2 gig or 2 for 1 (well, there is the obvious choice). However, I would like all 6 gigs to have. Could this have something to do?SemyStall
I don't think that's the case. Separately they work. Don't work unless paired with other dice to start.
Heretic_x68
Put the same timings for the slowest bar (the large digits, example 8-8-8-24 and 7-7-7-20 not) and put the same voltage at the greedy bar (1.8 V-1.85 V). Usually the timings and voltage written on the labels of memory. If the modules with different frequency, then you need to put in the least (such as 667 instead of 800).
Heretic_x68
On most motherboards in the BIOS by pressing comes to Delita after inclusion, but there are manufacturers where you have to press different F (F2, F6) . On the ASUS shares after the bell at the start-up screen.Usually on the splash screen it says to press. There are times when the BIOS can not go with a U. S. B. keyboard. Then we have to peretyat ports at boot or find a PS\2 Claudia.
Спойлерhttp://forum.skunksworks.net/Forum14/HTML/001592.html
Ryazancev
the problem is that when you try to run all the installed dies, the computer when you turn the stupid beeping. Or do you mean, two dies to run the BIOS to put the right timings as the slowest die, and then supply the rest?)
Ryazancev
In General, about samsonovsky dies I mean the timings could not know. However, I have another die to 2 gig. It is also not want any run in pairs. I want to put it. Those that stand (for 2 gig), timings 6-6-6-18, and this die 6-6-6-15. Voltage at all at 1.8, and frequency of updates all at 800 MHz. It turns out, I only sync on the dice to change it to 6-6-6-18? And if so, where exactly in the BIOS do?
Heretic_x68
Top Advanced Jumperfree Of Configuration, Drum Of Frequency. Where to set the timings not found! Found only count timings from SPD. Pokapaysya where it should be.
Ryazancev
looked in the BIOS. Nothing anywhere close no. Found only the possibility of voltage but the frequency change.
Heretic_x68
Found! Advansed, the North bridge Chipset of Configuraes http://ru.gecid.com/mboard/asus_p5ql-em/?s=all
Ryazancev
Understood. I, as I understand it, the timing only change 15 to 18? The rest of the dies are similar.
Heretic_x68
Yes, you need to be slow. Voltage look at all, it may have to raise to 1.85. Read that dude it still doesn't work with different straps, bad compatibility.