Asrock B450 steel legend overclocking RAM
Sorry, it was this topic, no!The question is, gathered sistemku:
Mother ASRock B450 Steel Legend
Percent AMD Ryzen 5 3500X
A bag for the CPU PCcooler GI-X4
Video card(maybe temporarily) GIGABYTE Radeon RX 580 4096MB
PSU Deepcool DA700.
But I am a complete zero in the acceleration of the dice(Goodram Iridium [IR XW3000D464L16S/16GDC] 16 GB), where to go and what graphs to change, tell me. A photo is appreciated.
The first launch, the system dies put on the 21**MHz timings are not found
Александр110588
Can start with these two points, but they will not give you serious profit because the machine will be set to high timings.
Then, when ripe can climb to the timings (in the configuration synchronization DRAM:
It is also reasonable to play with the resistance, but only when a large acceleration. Watch whatever CR was =1 and Gear down is always enabled.
If you want to overclock up to 3333Мгц, it is necessary to set the timings 16-18-18-34-1T , NB/SoC Voltage =1.05 V, procODT =60 ohm
Go into the BIOS when starting the PC by pressing the DELETE button(you can hold).
NB/SoC Voltage =1.05 V, procODT =60 ohm not found
CR was =1 and Gear down is always enabled. It is responsible for what
Alexander110588 wrote:
NB/SoC Voltage q1.05B, procODT q60 ohm didn't find it
You haven't updated your BIOS.
Alexander110588 wrote:
The CR was z1 and Gear down is always on. That's what you're responsible for.
GD makes timings even even if your XMP is 15 or 17, the CR1 is a delay and when installed on CR2 the benefit of the acceleration is negated.
Hello everyone, please tell me, the dual azur mode doesn't work.
Completing all new
Mother Asrock b450 steel legends
Percentage 5 3600
Videkarta 1660 super gaming oc 6g
RAM hyperx black fury 3200mhz 2×8
Insert a1 b1 reboots, and2 in2 sees only one, when connecting in1 in2 sees both but not in dual mode, help please
Alex77741
A2-B2 are your slots. Look at the instructions.
https://download.asrock.com/Manual/B450%20Steel%20Legend.pdf
page 22
Reset CMOS. Refresh BIOS.
If it doesn't, it's a guarantee.
By the way, there may be a broken memory controller on the CPU. There were cases on overclockers.
Hello everyone, assembly
Percentage 5 3600
Mother asrock b450 steel legends
Cooler gammaxx 400 v.2
Vidyukha 1660 super gaming oc
Everything new, collected, launched, percent jumps from 3.9Hz - 4.15Hz, as well as the temperature of the processor from 30-45 degrees. How do you fix the problem that you've encountered???
And what ram timings can be put at 3200mhz (hyperx black fury 2×8gb 3200mhz)