Friezes in games

Stepi wrote:
What can be done to the Frisians were missing ?
Stepi wrote:
video card GIGABYTE Radeon RX 470 G1 Gaming 4G, percents AMD fx 6300
Nothing

Stepi
The processor is rather weak

MrWorld
what percent fit under none ?

Stepi
It all depends on the budget

MrWorld
the budget of 15 thousand

Stepi
If you want a processor for the future I advise you to save up. By the way, the Mat Board is what? Supports overclocking?

Stepi
Find b/the percents intel i5 6th generation ( 6400, 6500, 6600 ) the most inexpensive, but with a mandatory check and preferably with some warranty. Buying the remaining money budget motherboard for socket lga 1151, and certainly with the support of DDR3 RAM and you have RAM to change. And all can enjoy the high growth 20-30% productivity and without a single microryza and lag.

At the extreme, sell your fx and buy fx 83** , overclocking it to 4.5 GHz, and it is also much more stable. This will save half of the budget. Is that cooling will have to take good.

Artie
Thank you, will do so )

processor to disperse cruel into the blood, in the trash in a water bath
memory nostril elite that was all strahotna 16 or more gibbonas
videokarta much gibbonas extreme
if SSD is to remove it as it can give friezes
the paging file to seal over 30+ giboney
and maybe freezes will disappear or decrease.

Stepi
What can be done to the Frisians were missing ?
Drive tried?
Pay attention at what frequency the RAM works.It happens that the mother is by default puts it on the lowest.Hence the friezes.It is necessary to raise the frequency of the RAM and check

[Denis]
Properties memory bus
Bus type Dual DDR3 SDRAM
Bus width 128 bits
Ratio DRAM:FSB 20:6
The real frequency of 670 MHz (DDR)
Effective frequency 1339 MHz
Bandwidth [ TRIAL VERSION ] MB/s

Stepi
Try raising the RAM frequency higher in the BIOS.

[Denis]
to how many ?

Stepi
Increases each time by 1 step and test in games with friezes
I have Crisis 3, with the effective RAM frequency to 400MHz was the friezes.Raised to 800MHz + bus-mother overclock at 10%.When 880МГц those of the Frisians no

[Denis]
Well, poprobuyu. Thank you )

[Denis]
you need to change only the clock frequency of the memory ?

Stepi
800MHz is my max, it was stated on my straps.The motherboard itself puts a 400MHz machine. I 880Мгц raised,without touching the timings and naprugu.If your straps claimed more than put the mother to pick up these frequencies in the BIOS.But you have to consider that the mother needs to keep a higher frequency.

[Denis]
I set 800MHz and timings 9-9-9-27 voltage leave on auto ?

Stepi
Efficient 1600?Test in games

[Denis]
aide in 64 I for some reason does not display the RAM voltage, and I read everywhere write that default standing 1500