Soap graphics. (Fernbus Simulator)

Started the game a year ago - everything was fine. After a while, I re-installed Windows 10 (clean installation).
The other day I re-installed the game (off. version of Steam). I run, all graphics settings at the maximum, and scale - on 87. I start the game, and there's soap everywhere. Googled this situation - advised to put the scale not 87, and 120-200. Supplied (tried different values from the range). In the game, of course, immediately dropped the number of frames, but it did not get better. Unfortunately, when you enter the game, everything is drawn normally (and sometimes it's all bad at once), and as soon as you get on the bus and a little bit, the soap returns, but it becomes even worse than at the value of the scale of 87.
Processor: Intel(R) Core (TM) i5-7300H's CPU q 2.50GHz (4 CPUs), z2.5GHz.
Video card: NVIDIA GeForce GTX 1050.
OP: 6GB.
Drivers on the graphics card and built-in graphics are fresh, because the system has been re-set recently.
Other games have no problems, but they are not built on Unreal Engine 4.