Why is the game so tightly slowed down? (Cyberpunk 2077)
I have a cut refuses to work normally Cyberpunk. No matter how I play with the settings. I watch the video, people on similar assemblies it in ultra goes 60-70 phps, I have on high at night 30 in the afternoon 50-60.The build I have is:
Rtx 2060
Ryzan 5 2600
16 Yb ddr 4 2666 Mhz
Ssd 256
Hdd 1tb
The game I put on hdd. I don't think anything depends on him. I've updated the driver, but nothing helps. Could this be because I haven't cleaned my comp for a year from unnecessary files, as well as dust?
Razerilyaq wrote:
I don’t think anything depends on it.
You shouldn’t think it’s useful.) Switch to ssd, even in the recommendations it is worth playing on it
Razerilyaq wrote:
Cyberpunk refuses to work normally for me. No matter how I play with the settings.
Because the game is not enough 16 gigs of RAM. Of which 2 are taken by Winda.
Razerilyaq
Disable rtx, well, the frequency of the RAM is small, it is desirable not lower than 3200. Well, the developers were not able to do it in a lot of stream on AMD, they should have fixed it with patch 1.05.
Razerilyaq
Cleaning is always at least minimal but it helps. Secondly, the overall quality of the RAM and power supply is very important for the risen. Take a good risen and vidyuhu, but for example to be greedy on RAM and vrm power and bp is sooooo rash.
I saw examples where ryzen 7 and video 2070 are super ... but bp aerocul is weak and mother on a B450 chipset with 5 or 7 phases I don’t remember, and there, in principle, under load everything sucks.
Marsj wrote:
The most fps-eating setting is fog.
no, the fog eats no more than 7-8 frames
Dron_Ur
Not in defense of the game, but you have to play it in 4k ... Unfortunately, the picture and detailing there transforms very well, for fun I checked it through super-resolution or whatever it is with Nvidia. Even at 1080p Monica.
XDDRUS
does it make sense to overclock the memory if the processor has a maximum memory frequency of 2666? percent i7 9700f
I resumed playing on my computer on patch 1.52, the game was terribly freezing sometimes, but always when I went to the map and sometimes in inventory and creation. At first I thought about video throttling, namely memory chips (3070 Ti). but the cold snap came and according to the sensors everything became normal. But the game did not stop freezing in the same way, with the advent of 1.6 it became easier, but still the friezes remained. It just added crashes from the game as if on a timer, and after a few crashes a blue screen appears in general. Is that what's wrong with her?
ace8927 khe khe
ruby ​​autosave in the bud - the most fake autosave. But no, it gets worse. Didn't upgrade to 1.6.
at 3080 in 4K, almost everything is at maximum except for tracing, the friezes are also not bad, and the vidyukha obviously rests brazenly and does not heat up more than 50, when in other games in 4K (the last FARCRY 6, Plague's Tale) the temperature exceeds 60
and this is even with tracing at the maximum, even without it at all, so the problem is clearly in the game itself
I tried a lot but still lags
. I have a laptop Lenova Legion
Rtx 3050 4GB
Amd ryzen 5 5600H
8GB RAM
Ssd 512GB
What can I do?
63737366
I think that 8GB of RAM is still not enough for this game, and there is hardly anything that can be done about it.
63737366
1. The cooling system in the laptop sucks, you have throttling in a couple of minutes.
2. video cards with an index of 50 are video bits, it's useless to run games on them.
3. Sooooo very few operatives
, therefore it lags, set the settings to low-medium, there will be norms.