Graphics card temperature.
Guys help I don't know where to dig. I reinstalled Windows on my computer because I decided to install ssd, in parallel with this I did preventive maintenance and replaced the thermal paste on the video card (GTX 1060 6gb), also replaced the thermal pads as the old ones just crumbled. After that, when you load the video card at least a little, the temperature instantly rises to 97 degrees and the screws turn by 100%. The same is true for tests in a lodge.Roman2555552
Tighten the mounting screws properly, until they stop. Cross-to-cross method. But without fanaticism, otherwise the textolite can bend.
This is if you are normal thermal paste, smeared with a thin layer. There are simply very thick pastes and if you squeeze out a drop, then there will be no pressure.
Bad contact of the Chip with the cooler base.
Ryazancev
if you look at the graph in the loft, then at the time of launching the test it instantly rises vertically from 40 to 70 degrees
Roman2555552
Yes. Exactly.
Re-do everything fine and the problem should go away. I came across this several times.
Throw off the pictures when you disassemble the vidyuhu and apply thermal paste ...
bazilews
I put it in a thin layer normally, smear it with a spatula, I just haven't come across this before
Roman2555552
The main thing is to do everything carefully and do not rush ...
How many of these vidyuh have disassembled and changed the thermal paste, but still every time I worry, what if ...
Ryazancev the
problem was found, after analysis it was found that the radiator did not even reach the thermal paste, we will fix it
Good day. I will raise the topic (suddenly someone responds, no, we will create a new one if the method in the topic does not help). The same story as the author of the topic. A 1070Ti card from gigabit, idle with disabled valves - 50 degrees (+ -), but it is worth entering any game, after a few seconds - 80 degrees and higher, valve revolutions - 70 - 80% (which becomes very noisy, because . there are 3). At the time of buying a card in the Superposition Benchmark program, max. the temperature was 71 degrees, now it is 90! The card is clean, the case is Z9 Plus, the wires are all tucked away under the back cover, 2 valves for blowing 2 for blowing out. Thermal paste Arctic MX 4, after application the temperature did not drop by a degree. Perhaps the same trouble as the author, the radiator does not reach, although he tightened the bolts with an emphasis "cross to cross" ... tomorrow then I'll try again.