Friezes (Battlefield 1)
People, can anyone have a similar problem.. I'll Start with the fact that BETA was doing fine without prasadam and packet loss. On release the game was terribly freesite after 20-30 minutes of play. FPS drops dramatically and restores, no matter WHAT the GRAPHICS SETTINGS are SET. The right picture is popping up, saying not enough FPS for this tickrate. Other multiplayer games, including battle 4 are fine.. i5 4440 8GB 970GTX.. I Read the forums, complain about the RAM, maybe 8GB to it in the... Again, the BETA was perfect.I have the beta too, was perfect now I noticed when you enable дрх12 hard lag disconnect works 100 times better
i5 - 3450, 8GB RAM, 480 GB RX 4. Yesterday I changed from Directx 11 to 12, in the game settings, changed the value to full screen on without frame. In the settings of the PC power supply was changed to productivity. Well, plus in the video settings in the game limited fps 60ю staff. Don't know what exactly helped, but fps even in 64 players became more smoother and lower 50 shots didn't fall like that.
AMD FX 8300 3.3 , 8 GB RAM, RADEON R9 380 8 GB, dx 11. Fps in all modes 40 to 60(limited to 60 frames), there are 38 falls very rarely, mostly in the region of 50 everywhere. In the capture ~25-50, to play really impossible. Graphics on ultra, which is the minimum salary that the minimum resolution has absolutely no effect on fps. The problem is the percent for you? Or is there other options?
ICYMEANSCOLD
Amd fx 8320e,8 RAM,r 9 380 4 gb msi.the percents are dispersed on the 4.3 swap file 16 GB.for ultra-high 60-50 fps(locked at 60 no syncing ,no Loka FPS jumps up to 80).VRAM hawala 3600 approximately.Percent loaded on 96 percent of max Percent needs to be properly driven.
600m
in General, dispersed percents to 4,2 , put a 16GB swap file. Increase fps of 0%. Also noticed that % and the graphics card is loaded on 100%, is this normal?
ICYMEANSCOLD
is this normal,can a virus.I have a dozen so it was still hard and scored 100% and everything lags severely.now at seven all good.the same system should all the rules be.and Yes!!check dual channel mode of RAM FKH like dual channel mode.the growth is palpable.
600m
What is dual channel mode?
Noticed a strange thing - can completely hang the PC for a while (up to 2 minutes) and kick back , or reboot with the message on your PC there is a problem
No viruses, hard new drivers are latest , windows 10( 7ka tin like retards in all games, I don't know what is)
ICYMEANSCOLD
Over ten,put another semeru.10 bends hard disk and the CPU in idle at 30% -40% loaded( I like it).docany mode RAM is when 2 dies are inserted in 1 and 3 slot.for fx it is very important.
ICYMEANSCOLD
In my percent, for the capture of 64 helmets fps drops. In small assault it flies.
Said goodbye to slowdowns in BF, only when the iron is updated. Changed the i5 760 and 8gb on-6700k i7, 16 gb - all was super smooth.
it is not the amount of RAM put another prog wise memory optimizer, nothing should be cleaned just after its installation freezes almost disappeared, too long suffered ever RAM 6 gig not filled with the game on the SSD the page file on another SSD so try other SEOs did not help!!!
I have (just for dx12) inhibited and even hung out menu, had poor navigation. And dx11 didn't want to go. Helped in the vidio settings to reduce the frame limit from 200 to 60 (as herculist my monitor) and everything started to fly.
i5-6500, RX480 8Gb, 16Gb DDR4
I, too, like a normal fps, but the gameplay uncomfortable, like brakes, seats are sagging and small friezes, apparently the game engine curve, and it loads the two streams periodically on 100% and 4 generally idle
the command RenderDevice.RenderAheadLimit 3 helps, for some reason, a few of Ru segment knows about it, and all the games with the engine frostbite.
I had earlier friezes on dx12, dx11 set and friezes disappeared, now with the newer drivers the problem disappeared about six months ago)))