Mysticism with iron. Please help.
Greetings to all. I summarize my problem. Today I changed the thermal paste on the CPU. Turned on PC, went into the game and found that the temperature plummeted well understood that smeared the toothpaste carelessly and climbed to re-apply thermal paste on the CPU. All neatly removed, no metal products in the process is not used, all bumazhechki, very carefully. The second time struck, everything is fine, put a cooler (Intel box), but turned it 90 degrees and then it began...Include PC and... kind of all started, the valves rotate ... but then I realized that the launch was delayed.. just my attention was attracted by a steady red LED on the motherboard (usually under normal startup a couple of seconds will burn out and all) also, I noticed that the fans of your graphics card trying to run but can't.
In General, all of the above lasted about 5 seconds, after which the system was out for 2 seconds !! And after 2 seconds, tried to re-start. That is all turned off, and then started the cycle. I turned off the power, I thought that the CPU is bad fixed and something else.. in voschem removed, checked everything was recorded perfectly and included..
Well and further all under the scenario - click on the start button - the system will start trying pulse, that is, pressed the button - the pulse (the fans trying to get started with this red LED ) - stop. And then in a circle.
Please help !!. Many times changed Ernesto, himself the PC has collected, changed parts on it but this is a first. I measured the voltage in the socket tester - all right, that is a problem with the power lines is eliminated. The valve on the BP as well can't start.
Thank you in advance !
PS People are not versed please do not unsubscribe !
Iron new.
i5 6400
MSI H110M PRO-VD
COOLER MASTER G450M 450W
bazilews
It is not true that if the mother died, the power supply will work. May not work connected to the outside of the Board, despite what the damage.
I had a similar cyclic turning the PC on gigabyte, decided itself, as disassembled, and assembled all the components and reset the BIOS by removing the battery for 1 minute.
Martin Ratnikov
Here is a direct exactly the same thing happened on an old computer,too, did not understand what was happening,I just took out the BIOS battery and RAM,then put everything back and it worked
look legs on the Prots under magnification.one or more are bent, I have a point to point also was.gently with a needle straightened.ugh ie in the socket and not on the percent)
Shalfey2221
Do. Found that 1 leg is bent on the socket, but ..... AS ???????????? Change the thermal paste for more than one year, do it skillfully.. in the end is how one could bend ?? I the slightest effort is not made, all neatly done. -_-
Martin Ratnikov
So I immediately came to mind,too, not just the system unit went through,and how to bend managed to not understand...)
Martin Ratnikov
Tip for the future before installing the CPU to check the status of the contacts in the socket.I personally take pictures on a digital camera with zoom,but can be under the lens to check...
I had the same thing when after the Assembly started to sink down the power button.
Martin Ratnikov
I looked at your problem and here is what I can advise.
1. If the motherboard is broken it can be replaced but...
2.If it burned down it could take the CPU and everything else except the railway and the PSU.
3. To find out what sluchilos need to go to Service center and let it check every detail.
4. In identifying 1-5 reap their bent legs straighten with a broken will do nothing and will have to change the mother. But to burn a socket could not.